All in a days work...

OLD MOTHER SATIVA

Well-Known Member
I don’t like the machines. Really hurt yields
I run the material till my returns are not worth my time, but the more you run it the quality goes down, if you want the full melt gold, I usually treat the 1st run , as if I’m doing an QWISO run, material at the bottom
Ice on top, poor very cold water over the ice , don’t let material mix with ice , keep it at the bottom, put the spoon at the bottom, little hand mix, 15-30sec n pull n screen,
I use big Pyrex dishes, all labeled size
Then I keep the runs separated.
When I’m all done , I mix it to my likings for what I want with it.
if you don't like the washing washing machine how do you get the glands to separate

this?
material at the bottom
Ice on top, poor very cold water over the ice , don’t let material mix with ice , keep it at the bottom, put the spoon at the bottom, little hand mix, 15-30sec n pull n screen,
 

BigHornBuds

Well-Known Member
Depending on what I’m looking for
If I want cream, that’s what I do.
Then I’ll run it again with a drill with a wooden spoon, give her a mix , n settle n pull( This is really good too) I find the quality goes down a little every run.
Then I’ll put the paint mixer on the drill, n mix .
If I just want a big piece, I’ll just go straight to the paint mixer .
If I’m looking for less yeild but better quality
I go gentle so I’m not busting glads , if I want yeild , I go hard .
Even when I go hard , I’m still making high quality(I’m careful enough not to get plant matter to small)

If your plant matter is just sitting in the ice mix while your straining , your losing .
Always keep things suspended .
And don’t reuse the filtered water , always fresh n chilled .
 
Top