• Here is a link to the full explanation: https://rollitup.org/t/welcome-back-did-you-try-turning-it-off-and-on-again.1104810/

LED strip gurus around here? Stop by and check out this vertical setup that needs tweaking!!

Sir420

Sir420

Active Member
I think I'll come out cheaper going to home Depot and asking them to build a custom light or them recommending me where to go
 
Sparky123

Sparky123

Well-Known Member
Sir420 said:
I think I'll come out cheaper going to home Depot and asking them to build a custom light or them recommending me where to go
Click to expand...
I’m a master electrician in Canada. I can tell you for a straight fact. Homedepot won’t even know where to start on this. They barely know how to hang a light let alone design one. I have ideas on how to build the proper fixture but it’s way to complex to even attempt to describe from my head
 
JohnDee

JohnDee

Well-Known Member
Sparky123 said:
I found this as well. But it’s also $560 plus shipping. Add that to the cost of everything else he’s talking about doing. Just the cost of a true High pressure aeroponic and the LEDs. Interested to see him actually attempt to build this
Click to expand...
We are talking pipe dreams...aren't we? Money isn't an issue in that case. 8)
JD
 
Sparky123

Sparky123

Well-Known Member
I mean you don’t need the fixture to fully spin. You want to hang 9 light bars correct. Therefore 360 degrees /9 = 40 degrees of rotation. So theoretically you could have the fixture go left and right 40 degrees and not fully around. Means you won’t need a slip ring connector. Just have a hanging loop for each power cord to allow for the 40 degrees of rotation
 
Sir420

Sir420

Active Member
Guys this is 100% happening I have the funds for this project I just need guidance to make it really come to life
 
JohnDee

JohnDee

Well-Known Member
TEKNIK said:
I didn't say it wasn't possible, I was referring to reliability over a practical solution. It's just not worth the fuck around as opposed to running some more light bars to get the even coverage
Click to expand...
Ah...now we get into the discussion about light movers. Some people like them...some people don't. Not in the mood for that discussion...
JD
 
TEKNIK

TEKNIK

Well-Known Member
If you absolutely have to have rotating lights then maybe look at how a merry-go-round works. It will be much stronger having the motors and drivers underneath rather than hanging. I don't see the point in rotating the lights other than wow factor
 
nachooo

nachooo

Well-Known Member
TEKNIK said:
If you absolutely have to have rotating lights then maybe look at how a merry-go-round works. It will be much stronger having the motors and drivers underneath rather than hanging. I don't see the point in rotating the lights other than wow factor
Click to expand...
Yes..leds are cheap now, and rotating devices with lights...I think they are prone to accidents...
 
You must log in or register to reply here.
Top