Led lighting for an 6.5x6.5 x 9

Powertech

Well-Known Member
I don't have anything against any other company, but I also can not speak highly of another company because I have not used one for my build
 

Powertech

Well-Known Member
This is my bxeb fixture I did this one a little bit different but their would be a different way to do this that would be easier my second light is my cutter light I’m not completely happy with but it works I wish I just went the bxeb route for it. But this is the general idea lots of other people that make strip lights I just need to make the wires for clean.
I still need to build the frame for mine lol! Not sure how good it will look yet but I am going to attempt to make it out of EMT and hide the wiring in the frame. Way cheaper than aluminum square tube like i want to use
 

Gond00s

Well-Known Member
I still need to build the frame for mine lol! Not sure how good it will look yet but I am going to attempt to make it out of EMT and hide the wiring in the frame. Way cheaper than aluminum square tube like i want to use
Yea many things that could be inproved on but u can always change the frame
 

FireBudzz420

Well-Known Member
Don’t listen to Mars just don’t
This is my bxeb fixture I did this one a little bit different but their would be a different way to do this that would be easier my second light is my cutter light I’m not completely happy with but it works I wish I just went the bxeb route for it. But this is the general idea lots of other people that make strip lights I just need to make the wires for clean.
That's bad ass man.
 

Gond00s

Well-Known Member
I still don’t know how I wanna hide the wire yet I might just use a double sided adhesive and run the wires on it or I could be really lazy and do zip ties but I’m open to suggestions
 

nmibud

Well-Known Member
Even for free I wouldn't waste my time with your shit lighting.You only changed the color of your diodes not the quality.
 

Humple

Well-Known Member
This is my bxeb fixture I did this one a little bit different but their would be a different way to do this that would be easier my second light is my cutter light I’m not completely happy with but it works I wish I just went the bxeb route for it. But this is the general idea lots of other people that make strip lights I just need to make the wires for clean.
What is it about the Cutter build that you aren't happy with?
 

X6xsilverx6X

Well-Known Member
OP go with HLG, or one of the other top brands, diy is cheap and easy with HLG, at worst look for used HLG lights on craigslist and ebay.

Dear ,any misunderstanding for mars hydro?you must haven’t use them,you will be grew attached to them after using them.~by the way,420 giveaway already start, you can join .
How about this instead of a give away, why not give your light to some growers that can then compare how your light would stack up against say HLG, or Amare? or any of the other big names. I would think hybrid would do a comparison for you.
 

Gond00s

Well-Known Member
OP go with HLG, or one of the other top brands, diy is cheap and easy with HLG, at worst look for used HLG lights on craigslist and ebay.



How about this instead of a give away, why not give your light to some growers that can then compare how your light would stack up against say HLG, or Amare? or any of the other big names. I would think hybrid would do a comparison for you.
They just won’t they know their garbage compares to hlg
 
Top