400w Club-Show Off Your 400w Pride And Joy

smokecabbage420

Well-Known Member
Thanks for the advice. I have nightmares of males infecting my females. I get the magnifying glass out and pull them out if i find any. But now that I'm cloning I will probably use seeds less to reduce the chances of pollination and have less stress. Thanks again, any advice if greatly appreciated.:weed:
Yea man u gotta look out for contaminating ur crop happened to me just by bringing an old pot (that had a mature male in it to make seeds) into the same room as my auto aks and sure enough they all have seeds... So be clean or stick to the clones.
Pce
 

jerkin247

Well-Known Member
fuck makin seeds, thats what profressional seedbanks are for. fuckin males knockin up bitches. WTF who makes seeds, its like makin reg man
 

atxbudgrower

Active Member
fuck makin seeds, thats what profressional seedbanks are for. fuckin males knockin up bitches. WTF who makes seeds, its like makin reg man
constantly buying seeds could easily get expensive and you cant keep that mother going on forever technically you can but i say sacrifice one female to get a good amount of seeds and not worry later on why pay for 10 seeds when you can pollinate one female and not worry bout seeds for a long time plus its free i dont see reason on wasting money but i guess its up to your own priorities
 

BlackRoses

Well-Known Member
Hey growers..
Just switched from growing under 250 to 400W.
I have a setup of:
1x 400W (55k lumens)
2x 125W (red spectrum flowering CFL) 16200 Lumens
2x 105W (blue) 11000 Lumens
In a Growbox L, growing 2x White Rhino and 1x El Niño

Comments are more then welcomed ;)

 

tahoe58

Well-Known Member
plants are looking great, colour, form, looks like a special grow .... a lot of side-light and great top light ..... this should rock. Good luck, I'm looking forward to watching. Walk on!!~~~~
 

BlackRoses

Well-Known Member
plants are looking great, colour, form, looks like a special grow .... a lot of side-light and great top light ..... this should rock. Good luck, I'm looking forward to watching. Walk on!!~~~~
Awesome! I really hope it does..
I wanted a 600W, but thought it could get a bit too warm inside the tent, so I decided to do something slightly different ;)
 

tahoe58

Well-Known Member
different it is than typical small grows .... good on ya ..... I expect your results will speak for themselves .... Walk On!!~~~~ :leaf::leaf::leaf::leaf::leaf::leaf:
Awesome! I really hope it does..
I wanted a 600W, but thought it could get a bit too warm inside the tent, so I decided to do something slightly different ;)
 

litljohn

Well-Known Member
Hey growers..
Just switched from growing under 250 to 400W.
I have a setup of:
1x 400W (55k lumens)
2x 125W (red spectrum flowering CFL) 16200 Lumens
2x 105W (blue) 11000 Lumens
In a Growbox L, growing 2x White Rhino and 1x El Niño

Comments are more then welcomed ;)

looking pretty good.what size is that tent,and what are your temps like.do you use a fan for exfaust.sorry for all the questions but im wanting to do a set up like that but wasnt sure how it would run as far as temps and stuff.
 

aagiants1

Well-Known Member
Hey 400 watters! i just got a 400hps the other day, sunleaves enclosed ballast...I thought i could control the temps with my exhaust fan that i have, but its a steady 90-91 degrees in there, and the ballst is very hot, you can put your hand on it, but not for too long. My question is can you guys point me in the right direction for a good, SAFE, not too hot, and reliable 400hps? I'm returning the one i have, and want to get one that the light and ballast are seperate...You know like i'm sure all you guys have! I've got exhaust hooked up now, so all i'd have to do is unhook the exhaust and hook it to the light, and draw fresh air from down low? Can you guys help me get a good light? Thanks!:clap:
 

litljohn

Well-Known Member
Hey 400 watters! i just got a 400hps the other day, sunleaves enclosed ballast...I thought i could control the temps with my exhaust fan that i have, but its a steady 90-91 degrees in there, and the ballst is very hot, you can put your hand on it, but not for too long. My question is can you guys point me in the right direction for a good, SAFE, not too hot, and reliable 400hps? I'm returning the one i have, and want to get one that the light and ballast are seperate...You know like i'm sure all you guys have! I've got exhaust hooked up now, so all i'd have to do is unhook the exhaust and hook it to the light, and draw fresh air from down low? Can you guys help me get a good light? Thanks!:clap:
yeah,get a remote ballast and keep it out of the grow room.this will drop temps several degrees
 

aagiants1

Well-Known Member
but how hot will the ballast get if i leave it outside the grow area? Will it be safe and quit enough? What brand light is a reputable one? Any and all suggestions greatly apppreciated...Also not sure what kinda fan i should use, inline or can fan? thanks again!
 

g00sEgg

Well-Known Member
but how hot will the ballast get if i leave it outside the grow area? Will it be safe and quit enough? What brand light is a reputable one? Any and all suggestions greatly apppreciated...Also not sure what kinda fan i should use, inline or can fan? thanks again!
Look around for light brands, now that I think about it...I don't know what brand my light, nor my ballast is..haha

As for fans...it really depends on your grow area. Can fans are much more effective, but unnecessary if you're growing in a smaller area. A good inline fan is your best bet for a smaller grow area. I picked mine up from lowes...It's a 6" duct fan...i think it was 30 bones?
 

aagiants1

Well-Known Member
It looks like lumatek is a popular ballast? I just want to make sure its safe, and cool are the ones i'm worried about...I love RIU! You can get answers to just about anything if you ask! Thanks all!
 
Top