Recent content by Mister_Green

You're a star! Judging by those numbers - ill keep the VO on max and just adjust the current as needed :)

Okay, i have adjusted the io (current)... the light dims fine. Although, the Voltage adjustment screw also dims the light. Should i not touch this? Any idea of where the voltage should be set... full whack?

@RandomHero8913 Sorry for the confusion pal, I meant which one in the picture do I adjust.

Which screw do I use to adjust the brightness of the lights?

I'm pretty sure the colour of the connectors is irrelevant. As long as the wires match and are making a proper connection, you will be fine. You can't see the connectors vey well, but see attached picture of how mine are wired.

If you put the driver diagonally across the centre you'll find two holes that match. Creates an even weight distribution too.

Nice one! I'll go put them on now.

Cheeky fucker :bigjoint:

Oh wait.. The penny might have dropped. One plastic bolt next to each power connection on the board? So they act as 'feet' or 'stoppers'? Or am i still way off lol?

@robincnn I have no idea what you just said regarding the plastic ones haha! Could you explain it as if you were speaking to a child? Would be much appreciated :-D

Not sure regarding the plastic ones. The longer ones I have used for mounting the driver to the heatsink

I have mounted the driver on top of the board now as suggested by Lukio. So no issue anymore :cool: I have also changed the connection on the mains. See pic.

Mine arrived this morning :clap: I think it's all setup correctly! Blinded me when I turned them on 8-) I just can't figure out how I'm going to raise and lower the lights due to the cabling from the board to the driver being relatively short.. any suggestions? Also, what are the rest of the...

@StonerCol Ah I didn't know you were on here buddy! :mrgreen: Ha, I was just babbling away.. my mouth travels faster than my brain sometimes :eyesmoke:

Wow.. I just re-read that back! Interrogation much :shock: My bad LOL