Rahz's latest activity

Thought I would update. PHing to 6.2, still using soiless HPCC mix. Added UVA/UVB as detailed in previous post. Saucers replaced with...

I wish I could have gotten away with that. There are various factors involved including location.

I just use my pressure cleaner to rinse the bins out never use bleach or scrub the bins and never had any sterilizing issues in all my...

DWC is great but between grows you need to get as close to sterilizing everything as possible. Sanitizing isn't enough. Bleach and scrub...

6063 should be fine for your purpose. I wouldn't worry about it.

Maybe all you need is to lay a few corrugated PVC roof sheets down into each table, so they runoff like a roof onto the next panel, and...

As long as it goes straight to the drain you should be fine. Aluminium is otherwise not very recommended to use to build a system for...

Thanks for the consideration. It an alloy (6063) that is corrosion resistant and I don't think there will be much if any re-uptake from...

Tables finished and in place. The last pan I tilted slightly so water flows to the corner where the bulkhead is located. The two lower...

Thanks and yes, about 1000. I might have saved about 100 using a thinner sheet metal. The hardware alone was about 150. It's crazy how...

Pics. It happened alright lol.

In reply to both it's made from hash the plates are 5" x 4" and the hash is pre pressed into 4" x 2" for the filter bag (37u, double...

Did a quick search for relavent posts but no joy.. so I made a rosin press a few years ago and up until now it's done me fine and been...

I has the sheets pre-cut but I cut the rest myself: chop saw is a very useful tool for cutting metal up. Another useful tool: deburring...

Might as well add the build specs. I did run load calculations and research the alloys so if anyone does something similar it should be...