Search results

800-1000 is where i thought I should shoot for. And led gardener?'s video was showing 6 hundred something ?dead center 24" above.. I could be remembering wrong. And of course those numbers would go up when multiple boards are used. All speculation for me right this moment

Or 3 260 kits and blast em?

So maybe helpful with landrace sativas...?

Can these cords be purchased separately? Or can you post a link to where they can be had?

This was my experience too :clap:

Does the slate 2 have more cooling power than the slate 3? Any word on the optics?

So would it run fine with say 3 maybe even 4 288 boards on the 1050? But each board will be running fewer watts? Also the 2100 ma will run hotter than the 1050 correct? Sorry im just trying to make sure im following correctly.

Will the 1050 run 2 288 boards ok?

Im not well versed at reading these but those 4k's look good to me.. similar blue as the 5k but w similar reds as the 3k. I purchased 3k and im sure they will be great

That'll work, thank you.

I maybe blind but I haven't seen or can't remember seeing the option for check out notes during my ordering process.

I would like to wire 4 288 boards together in series. Im eyeballing the 135 watt kits but would like to limit the number of drivers/plugs. Do you stock a driver that can power all 4 in series that can be wired up for 120v plug? Or am i better off buying the boards /heatsinks from you and...

Would this be available as a 4 135 watt board kit?

I had ass-u-med the 260 kit was pretty much just 2 135 kits but only 1 plug/driver. Would there be a way to daisy chain a few of the 135's together to reduce the number of things to plug in? Thank you for your time and attention!

Sold! Would it be wiser for me to wait for the slate 3's in may? and just add the slate 3's to the 260w kits for an extra fee? Or shall i get a kit or 2 to play with and just upgrade to slate 3's at a later date. I would hate to wait and then miss out and have to wait again for restock. This...

This as a 260 w would do well over a 2'x4'?

Thats great about the optics! The efficiency is a little greek to me. One more week.

What is the efficiency for the 260 w kit? Once optics have been glued on can you still remove the boards from the heatsinks? So they can be changed over the the slate 3..?

Barely...! :cool:

Nice! So assuming the 260w kit was installed on a slate 3; with the space in the center. Would that keep the flowering footprint the same? (2x4) or would the space water it down too much? Thank you for all your hard work and guidance.