Search results

Strains make a difference. I had Sativas that never wanted to finish in my time frame. My hybrids were well done and the Sativa had a ways to go. The harvest is drying so I’ll have a weight in a couple of weeks. This was the typical development for the strain I ran @59 days of 13/11 at harvest

They’re Sativa Dream from Kanubia. They’re from seeds I feminized. yes13 on. Three to a pot is best. The veg is a week or two. Harvested yesterday. They were outstanding. Even my 12/12 Growmie was impressed

The reached maturity in 59 days. They looked better than I hoped.

Day 12 since 13/11

My Hybrids did just fine under 13/11 so I’m running them again under that regime. They’ve shown pistles after 6 days. They should be done, on schedule at 10 Weeks.

I’ve grown in Hempys for years. We found that our indoor grow does best with 70/30 CoCo/ Perlite mix using Jacks 321 Outdoors, we use Turface as its weight keeps the pots from blowing over. JM2¢

We feed full strength Jacks 321(1100 ppm with tap water), in 9l Hempy buckets 70/30 Coco/Perlite We run PH water ever 4th “feed” Here’s week : of flower.

According to the link Wollastonite doesn’t raise the ph in peet out CoCo. “- It is unknown why the pH of peat and coconut coir-based media with wollastonite did not increase over time.”

I’ve had outside plants start flowering by August 1, By the time we reached 12/12 in late September, the plants were pretty much done So, has anyone run 14/10 flowering and, if so, how’d it go? Thanks

It’s is horticultural Valhalla

Yes. Outside plants but showed no infestation.

I’ve been running Hempys for quite a few years. my best results came from a CoCo/Perlite mix 75/25 with the reservoir filed with only perlite. Fed with Jacks 321, this.method is foolproof, IF YOU USE BUFFERED COCO. I Buffer using 4.2 gms Calcium Nitrate and 1.4 gms Epsom Salts per gallon...

TY. My Growmie had us Chuck the 3 GMOs and had us run just these 2 Kush Mints, a Harder hitter. Lost a month of grow time. This is a low budget setup. Mars TS 3000 Mars 4x4 Tent ( don’t get one without side access). Infinity 4 in fan ( get a 6 incher). Hempy, CoCo, Masterblend, Drops PH...

We’re at the end of week six of flower. Substituted Cal-Nit with Cl- Suf. and upped the MB to 175%. Ran Kool Bloom Dry @ 1/4 tsp per gal, during Weeks 5-6. With reg Nutes We did have a heat/light issue briefly but raising the light fixed it. They’re being fed 1.5 gal of modified MB trio, a day.

“At 20C (68F), calcium sulfate dihydrate – the form most commonly available – has a solubility of around 2.4 g/L. In practice this means that you can have up to around 550 ppm of Ca in solution from calcium sulfate dihydrate before you observe any precipitation happening. This is way more than...

To get to the Calcium PPM right I’m running 3 Gms CS per gal. I based this on the fact that 2.4 Gms CS per liter, (3.8 Ltires per gals) will supply 550 ppm of CA. That’s appx 144 ppm per gal. I upped it to 3 Gms. Bringing the CA ppm to 180 per gal. JM2¢.

Just an FYI We run Masterblend throughout. This grow we replaced half of the Cal Nit with Calcium Sulfate at week four of flower. They didn’t miss the extra N and look healthier than ever. I’m undecided whether to totally replace the CN with CS after week 6 , on this 10 week strain. The MB...

Coco Hempy with Perlite at bottom 2 inches. Fed with Masterblend/CN/ Epsom. 600 ppm with Tap water PHd to 6.0. Just finished one grow and on to another. Ran 1130 ppm most of flowering. 20% runoff, always. JM2¢