Search results

  1. grasscropper

    best strain youve grown outdoors from seed in last 2 years?

    Done! It’s very damp here currently. Was away and came back and took that and some other areas down. Not too bad but she can’t take much more weight or wind.
  2. grasscropper

    best strain youve grown outdoors from seed in last 2 years?

    I know! It’s down. I am a woman. Hahahah.
  3. grasscropper

    best strain youve grown outdoors from seed in last 2 years?

    Romulan without a doubt. Haven’t fully harvested yet. Probably will do this weekend.
  4. grasscropper

    Wind damage

    We are working on it. Have learned from this one. She’s so big now that finding stakes this long and strong has been difficult. These were homely ladies at the start. Hahaha. Now does one start staking when small and keep going along the growing
  5. grasscropper

    Wind damage

    These girls are truly stunning. Last Of the line too Good morning fellow growers!!!
  6. grasscropper

    Wind damage

    The reallllky annoying part is I gave 2 of my crappiest babies to my bro. For a trial run. And bam. We have these monsters. Haven’t seen bigger in my life. Trimmed branches beyond repair. And hey it exposed some of the inner area. And we have trimmed back fan leaves all summer!
  7. grasscropper

    Wind damage

    These were stunning plants. Terrible. Broken hearts this morning. Bloom or flowering started early this year which is good as we can crop out earlier as well.
  8. grasscropper

    Wind damage

    Hey growers. I have a Romulan. Two actually that took a beating in Rain and wind last night. Haven’t touched it yet. Please made suggestions on how to deal with the aftermath of bullshit Ontario weather.
  9. grasscropper

    Ppm & runoff when feeding

    As far as when to water is concerned you should wait till the pot is light when picking up. Less is better. I have had a lot of issues due to overwatering.
  10. grasscropper

    Ballast, Bulb or Socket

    Seems to be working ok now. With the MH bulb but will try the HPS and see what happens. Also the ballast has a switch that you set from 10-110% power. I had it on 110. Maybe too much?
  11. grasscropper

    Ballast, Bulb or Socket

    Ok I will try that. It's currently laying flat and inside the tent. Maybe it's running hot in there.
  12. grasscropper

    Ballast, Bulb or Socket

    The cord was hot to the extension cord. So I moved it. Still did it.
  13. grasscropper

    Ballast, Bulb or Socket

    Thanks. I actually left the ballast pulled in no bulb so it was running. When I went back down stairs it was still going. Leads me to think that it's the socket. I put the MH bulb back in and put the switch to 50%. Was still running a couple of hours later. Just moved it to 75 and I will know...
  14. grasscropper

    Ballast, Bulb or Socket

    I have a 400 watt HPS electronic ballast that powers up and then shuts off after maybe 10 minutes. It has a reset button on it and I don't know if it's the ballast or not. I switched the bulb. Still does it. I took the bulb out completely and it still shuts off so it must the ballast right? Any...
  15. grasscropper

    i have mold at the base of my clones...

    Ok I get that. I have the dehumidifier on the room. But if you're trying clone in water then what? The stems become like over cooked asparagus! This has been going on for months now. I get the little bit of what looks like green/blue mould. Doesn't seem to matter what I try. Maybe I will bring...
  16. grasscropper

    i have mold at the base of my clones...

    I am having the same issue. My stems in hydroponic cloner are literally turning to mush about a week to 10 days in... My clones in rapid rooters fold over at about the same point... mold. I have used 27% H20 in the water of the hydro cloner... all when I add any water to the ones in rapid...
  17. grasscropper

    What am I doing wrong??

    Sure I grew autos outside. Gives you the ability to have several harvests depending on where you live. At least 2 where I am.
  18. grasscropper

    What am I doing wrong??

    No need to start over. Get the bulbs closer and the proper ones. Then when you replant bury those stems.
  19. grasscropper

    Can someone tell me why this is happening?

    I've had the same thing happen before with clones. Ends up working itself out for the most part.
  20. grasscropper

    Smoking weed doesn't make me high, it makes me well.

    Smoking weed doesn't make me high, it makes me well.
Top