bottom leaves wilted :( please help

I have a hydroponic deep water system my plant is 3ft 8inches the stems a beast and it's very bushy, altogether it's health I'm in the transitioning stage about to go into harvest and the bottom leaves have wilted I'm not to sure what to do or why it's happened i remember awhile back I was told this tends to happen because the higher leaves restrict how much light the bottom leaves see at this point I don't know what to do and was hoping someone could help
 
I have a hydroponic deep water system my plant is 3ft 8inches the stems a beast and it's very bushy, altogether it's health I'm in the transitioning stage about to go into harvest and the bottom leaves have wilted I'm not to sure what to do or why it's happened i remember awhile back I was told this tends to happen because the higher leaves restrict how much light the bottom leaves see at this point I don't know what to do and was hoping someone could help
Cannabis_Nutrient_And_Deficiency_Table.JPG
 
You say "transitioning" about to "go into harvest". Are these plants fully flowered and ready to chop?Or almost? Or are you just now flipping them to 12/12 to flower them?Pics are always very helpful.
 
image.jpg image.jpg
You say "transitioning" about to "go into harvest". Are these plants fully flowered and ready to chop?Or almost? Or are you just now flipping them to 12/12 to flower them?Pics are always very helpful.
I just switched the time to 12/12 along with the nutrients
 

Attachments

  • image.jpg
    image.jpg
    107 KB · Views: 5
  • image.jpg
    image.jpg
    93.6 KB · Views: 4
It's starting to get a bit big for its environment I wasnt actually expecting it to do so well the leaves that are dead are at the bottom and falling off other than that it seems to be healthy
 
It's starting to get a bit big for its environment I wasnt actually expecting it to do so well the leaves that are dead are at the bottom and falling off other than that it seems to be healthy
Are you measuring your EC/PPM? have you swapped the res out? It looks like you need to boost the P & K a bit and the micros at the same time.
 
Back
Top