correct driver for 6 diablo boards?

what options are there for parallel, hlg 600A 54v, i guess b version is not enough volts? If i use the A version for 6 boards couldnt i turn it wide open and be fine or do i need to measure as i adjust? what driver are they using now on the factory scorpion diablos?

Roguedawg said:

what options are there for parallel, hlg 600A 54v, i guess b version is not enough volts? If i use the A version for 6 boards couldnt i turn it wide open and be fine or do i need to measure as i adjust? what driver are they using now on the factory scorpion diablos?

Click to expand...

Yep, the voltage, Hard cap at 54v on with the B versions. A's can be cranked a little over.

With 6 boards ona 600w driver...it "might" work out to be right at 54V or under. Think inventronics is capped at 54v too.

Eldoleds horti drivers have 56V, so do Autec's. But either are readily available.

Could use (2) 320w drivers and run in series and not worry about it.

I would go with 2 320's in series if it was just one light, but i am making a couple. The two lights that are being replaced are using 2 320's per light and i would like to simplify.