MidnightSun72
Well-Known Member
Ok so I bought 2 SONOFF TH16s off Amazon These can control a circuit based on temperature or humidity (gotta buy a special sensor for humidty) . Each TH16 will run an 8" Duct booster fan that blows out of the tent and draws cold air from outside. SONOFF is controllable over wifi on the eWelink app. You will want to download this now.
OK so everything you need to run this as an inline temperature switch is in the below picture
Per SONOFF
1 Male 120V plug end
1 Female 120V plug end
2 lengths of electrical cable with two conductors and a ground
SONOFF TH16
SONOFF Temperature Sensory (Came with my SONOFF but they don't always)

Mount a male plug on one length of cable and mount the female plug on the other
Here we can see how they want us to wire it up. So following the legend your unit could be different.
Here's how I connected it up
After you plug it in a blue light start glowing. This when you want to go to your eWelink App. I taped over the cover cuz it sucks.

I ran the sensor into the tent

Then you go into the eWelink App in the Auto Section and set your upper and lower temperature limits MY temps are in celcius

That's all hope this helps someone.
OK so everything you need to run this as an inline temperature switch is in the below picture
Per SONOFF
1 Male 120V plug end
1 Female 120V plug end
2 lengths of electrical cable with two conductors and a ground
SONOFF TH16
SONOFF Temperature Sensory (Came with my SONOFF but they don't always)

Mount a male plug on one length of cable and mount the female plug on the other
Here we can see how they want us to wire it up. So following the legend your unit could be different.

Here's how I connected it up

After you plug it in a blue light start glowing. This when you want to go to your eWelink App. I taped over the cover cuz it sucks.

I ran the sensor into the tent

Then you go into the eWelink App in the Auto Section and set your upper and lower temperature limits MY temps are in celcius

That's all hope this helps someone.