q_tip201
Active Member
built a box with standard 2x4's and panelboard
got the entire inside sealed air tite with wiid glue and caulk covered completly in panda film.
both exhaust hole are sealed and the light intake and exhaust are clamped on dryer tubes
the room exhaust is an 80cfm fan hooked up to a diy carbon filter took a 8"to 4" reducer gorilla glued aluminum fencing around did the same to an 8" to 6" reducer
put em together sealed them together and filled the space with active charcoal and sealed the top on it
passive intake on the box with a dryer flap so when fans not running air isnt coming in
room fan is set to a thermostat to turn fans on when room gets too hot
all holes have screen across them to keep pests out
box is 60" tall x 28"w x 26" d
have a 400w Mh/hps light with sealed air cooled hood
a 80 cfm exhaust inline fan on light, passive intake. exausted to attic no carbon filter
the timer that controles the lights also controls the fan so that when the light is off the fan isnt running
all electrical hookups and apliances are wired to a power supply strip outside the box the grow box has its own circut breaker so no need to worry about popping the breaker
im using a bubbleponics system with hydroton rock and rockwool and twho seperate resivoirs that has o toilet systemso when the botom resivoir gets the the top one fills it back up this alows me to get the nutrients and ph right before it is allowed to affect the plant it is a 4 plant system the plants will have aproximately 36 1/2" to grow and also keep a 12" space between the plants and the lights
im not sure at how tall to send into flower and its an indica strain
i think i did a good job but constructive critisizm is welcome thanks everyone
got the entire inside sealed air tite with wiid glue and caulk covered completly in panda film.
both exhaust hole are sealed and the light intake and exhaust are clamped on dryer tubes
the room exhaust is an 80cfm fan hooked up to a diy carbon filter took a 8"to 4" reducer gorilla glued aluminum fencing around did the same to an 8" to 6" reducer
put em together sealed them together and filled the space with active charcoal and sealed the top on it
passive intake on the box with a dryer flap so when fans not running air isnt coming in
room fan is set to a thermostat to turn fans on when room gets too hot
all holes have screen across them to keep pests out
box is 60" tall x 28"w x 26" d
have a 400w Mh/hps light with sealed air cooled hood
a 80 cfm exhaust inline fan on light, passive intake. exausted to attic no carbon filter
the timer that controles the lights also controls the fan so that when the light is off the fan isnt running
all electrical hookups and apliances are wired to a power supply strip outside the box the grow box has its own circut breaker so no need to worry about popping the breaker
im using a bubbleponics system with hydroton rock and rockwool and twho seperate resivoirs that has o toilet systemso when the botom resivoir gets the the top one fills it back up this alows me to get the nutrients and ph right before it is allowed to affect the plant it is a 4 plant system the plants will have aproximately 36 1/2" to grow and also keep a 12" space between the plants and the lights
im not sure at how tall to send into flower and its an indica strain
i think i did a good job but constructive critisizm is welcome thanks everyone