HLG-600 H V2 - no assembly instructions?

Colo MMJ

Colo MMJ

Well-Known Member
My mate running licensed op for a test. I got him an HLG-600H V2. The light arrived and it had no assembly instructions at all??? I did not pay extra for assembly but I thought there would be basic instructions???

I am planning on buying 6 to 10 more for this licensed op in a legal state. I was looking forward to testing the V2. I saw a youtube video for the HLG 500 but it shows soldering. I am in another state right now.
 
GBAUTO

GBAUTO

Well-Known Member
Wasn't able to find anything online. I'd contact Growers Choice or see if you can PM Stephen@HLG and see if he can walk you through it.
 
Aolelon

Aolelon

Well-Known Member
Colo MMJ said:
My mate running licensed op for a test. I got him an HLG-600H V2. The light arrived and it had no assembly instructions at all??? I did not pay extra for assembly but I thought there would be basic instructions???

I am planning on buying 6 to 10 more for this licensed op in a legal state. I was looking forward to testing the V2. I saw a youtube video for the HLG 500 but it shows soldering. I am in another state right now.
Click to expand...
There are videos online, it's the same setup as the hlg600 v1
 
Aolelon

Aolelon

Well-Known Member
Colo MMJ said:
My mate running licensed op for a test. I got him an HLG-600H V2. The light arrived and it had no assembly instructions at all??? I did not pay extra for assembly but I thought there would be basic instructions???

I am planning on buying 6 to 10 more for this licensed op in a legal state. I was looking forward to testing the V2. I saw a youtube video for the HLG 500 but it shows soldering. I am in another state right now.
Click to expand...
It's honestly not very hard, screw everything in place ( you may have to face the boards so you can wire them right), wire 2 of the boards in parallel to one side of the hlg-600h, then wire the other 2 to the other connector on the hlg-600h.
Positive of the driver to positive of the board, positive of that board to positive of the next board, do the same with the negatives. On both sides.
I thought there were some assembly for it but that's the 550. I'll try and get a drawing if I can
 
Last edited:
Airwalker16

Airwalker16

Well-Known Member
Aolelon said:
It's honestly not very hard, screw everything in place ( you may have to face the boards so you can wire them right), wire 2 of the boards in parallel to one side of the hlg-600h, then wire the other 2 to the other connector on the hlg-600h.
Positive of the driver to positive of the board, positive of that board to positive of the next board, do the same with the negatives. On both sides.
I thought there were some assembly for it but that's the 550. I'll try and get a drawing if I can
Click to expand...
He's not gonna understand that hahaha.
 
Aolelon

Aolelon

Well-Known Member
Here is a picture I drew to help you, there might be slight variation, i havent seen the hlg600 in person, but this is how to parallel wire them. Positives to positives, negatives to negatives. More than likely, your driver will be attached to the back of the heatsink
20180630_010534.jpg
 
You must log in or register to reply here.
Top