Manfromthenorth
Well-Known Member
There so dim with the pot turned down that I can look rate at it and see the indivigual lights on the cob
Par readings
- Thread starter Manfromthenorth
- Start date
Manfromthenorth
Well-Known Member
There is only 32 volts at the cobs when I check pos and neg of a cob when the light is on
Manfromthenorth
Well-Known Member
what do I check for when checking connections I mean there all light up I have two lights built and there doing the same thing.
Manfromthenorth
Well-Known Member
On the out put side on the driver I'm only measuring 32 volts there as well. It should be well over 140 right this is while the light is running?
CobKits
Well-Known Member
from what to what? should be 140ish volts from driver pos to driver neg
you do have these wired in series, right?
Manfromthenorth
Well-Known Member
No I have it in parallel
Manfromthenorth
Well-Known Member
On driver pos and neg it's 142.
Manfromthenorth
Well-Known Member
It's a hog 185 c 1400 b that is soposed to be wired in parallel correct?
Manfromthenorth
Well-Known Member
Ok got it all working 
Manfromthenorth
Well-Known Member
Thank you every one for the help!!!
Olive Drab Green
Well-Known Member
Give it at least 100-200 more PPFD somehow. At least in flower. You want around 900-1200.
Last edited:
Manfromthenorth
Well-Known Member
I'll have to drop them closer that's all
Manfromthenorth
Well-Known Member
Does not take much to bring the numbers up a lot
Olive Drab Green
Well-Known Member
I'm sure, I'm just saying.
Manfromthenorth
Well-Known Member
No worries on this set of cobs man I ordered enough on the next order to replace these in case I blew them all trying to figure out how to make them work.
)
sixstring2112
Well-Known Member
I thought you wired in series also.did that one cob with a line missing go back to normal with proper voltage?
I have grown some ok nugz with 600ppfd i wouldnt worry too much about those new numbers,they are pretty good all thingsconsidered