• Here is a link to the full explanation: https://rollitup.org/t/welcome-back-did-you-try-turning-it-off-and-on-again.1104810/

Help name the deficiency

kush401

Well-Known Member
Hey what's up riu I'm growing my ladies on a flood drain there getting fed cultured solutions and ppm are at 190 and ph 5.8-6.0 all of them look great even the one with the deficiency but all her fan leaves are getting it. Her sister right near her is perfect right now. Temp 74 humidity 45% any answer help
 

Attachments

jugz420

Well-Known Member
How is ur air flow, and trow some cal mag, also you can spray them some silica, it will promote better over all health and will resist harsh temps...I keep PH at 6.8. - 6.9

-Jugz
-Mex 420
 

kush401

Well-Known Member
Small boy filter @terry358.. I also foliar feed once a week with neem, silica, photosynthesis plus, magic green.
 

jugz420

Well-Known Member
No this deficiency is starting from the tip of the leaf

Grab some Natria NEEM OIL. It works wonders!... Just spray it all over and under when lights are off stop air flow for like 30 mins then run it, do the same thing next day. then wait 2 days and check it. you will noticed next day your leafs will look shinnier and healthier. I am not saying this might solve your problem but again it wont hurt to try it. And is for organic gardering.You can get it at ur local home depot store. Good luck Kush401 =)

-Jugz
-Mex 420
 

Terry385

Well-Known Member
stop spraying the neem oil only use for bugs put silica in water mix ( to much spraying well cause P.M )
check ppm of water you well need to add calmag up too 200 ppm than add nutes. don't go over 400/500 for week 4 if that's where you are at
 
Last edited:

kush401

Well-Known Member
There only week three and in dwc I thought was always lower then soil I haven't added calmag with cultured solutions so many that's what it is
 

jugz420

Well-Known Member
stop spraying the neem oil only use for bugs put silica in water mix ( to much spraying well cause P.M )
check ppm of water you well need to add calmag up too 200 ppm than add nutes. don't go over 550 /600

Agree, I was just suggesting in case of powdery Mildew and the bug he posted, but yea silica is where is at. =)

-Jugz
 

Terry385

Well-Known Member
don't know what nutes you use but this feed chart is for DWC i use for ppm's weekly now i use their products
feed chart.png
 

kush401

Well-Known Member
I'll do a water change tomorrow and put it to 250 ppm see how it works just would like to know what's wrong with her cuz her sister right near her off the same mother is fine nothing wrong
 

Terry385

Well-Known Member
pic one shows some thing hot in root zone like root rot that why i ask what roots looked like
now just may need calmag leaves well always show the damage look at new growth
in my pic you can see the leaves that where affected new growth looks good
WP_000181.jpg
 
Last edited:
Top