800W LED Newbie indoor overgrow prob!! Please help

FRANMACHINE

FRANMACHINE

Well-Known Member
SEE IMAGE BELOW FOR INDOOR LED GROW PROBLEM PHOTO

Setup: 1x15 gal res; DWC -- 2 Plants, 8 colas ea.; Super Lemon Haze -- 1x600w LED, 2x100w LED -- 800w Total. **FLOWERING SINCE 11/28/15**

**I know -- Res too big, plants too close, tent too small

Should I massive defoliate? Lessen the water in my resevoir?

**Hey guys i have no access to any immediate merchandise remedy.

Help would greatly be appreciated. Thank you!
 

Attachments

Last edited:
whitebb2727

whitebb2727

Well-Known Member
Raise light. Look up super cropping. Basically take each stem at the bottom and squeeze the stem flat like a straw. Between your thumb and pointer finger. You may have to work it a little. You want to feel the tissue crunch and soften. Then just break the stem. Bend the stem sideways and flat after breaking.

I know it sounds crazy. It won't hurt them. They will grow a knot at the break. It actually causes better growth.
 
FRANMACHINE

FRANMACHINE

Well-Known Member
HookahsGarden said:
Raise the lights. And tie down the plants using lst (light stress training)
Flip to flowering mode.
Clean up the bottoms to focus growth at the top of the colas.
Grow on!

Peace
Click to expand...
I am almost 4 weeks into flowering. How do I clean the bottom? Do I remove the fan leaves or the branches?
whitebb2727 said:
Raise light. Look up super cropping. Basically take each stem at the bottom and squeeze the stem flat like a straw. Between your thumb and pointer finger. You may have to work it a little. You want to feel the tissue crunch and soften. Then just break the stem. Bend the stem sideways and flat after breaking.

I know it sounds crazy. It won't hurt them. They will grow a knot at the break. It actually causes better growth.
Click to expand...
Ill try this out!! From where do I bend the stems? Can I bend multiple times for 1 cola?
 
You must log in or register to reply here.
Top