bassman999
Well-Known Member
This is for the CXb3070, AFAIK BB still the top bin for themWhat about CD?
This is for the CXb3070, AFAIK BB still the top bin for themWhat about CD?
They look good so I got these http://www.ebay.com/itm/231507476233
Mine work so far and I wanted a knobThey look good so I got these
http://www.ebay.com/itm/231507476233
Same one, and they are small in person, at least compared to the ones I use for tweeters and I wasnt expecting that.bassman did u use the same exact item / pot ?
I can't tell a good one from a bad one
Those drivers arent used yet, but I have a pair of 240's with these soldered to them.where did u mount that ?
have u soldered one yet ?
why?You may just wanna get 2.5&2.8 mm bits and M3 self tapping screws instead of actually tapping
Aluminum is soft enough. It's a lot of extra work tapping the holes. You can if you want, but don't use an all in one like that. Use a 4-40 drill and tap set the drill is smaller than the actual tap and is made so it can work with threads. Those flat bottom screws are great if you have it tapped. But that's the only way they'll go in.why?
2.5-2.8mm? I already purchased the tap and center punch. I do not have metric size bits but I can purchase if you really think it is easier.Aluminum is soft enough. It's a lot of extra work tapping the holes. You can if you want, but don't use an all in one like that. Use a 4-40 drill and tap set the drill is smaller than the actual tap and is made so it can work with threads. Those flat bottom screws are great if you have it tapped. But that's the only way they'll go in.
With m3 screws, using a 2.5 for pilot, then a 2.8 after gives your screws just enough width to "press" it's own threads.
I dont see any cobsThe drivers. Fuck yes.
View attachment 3596242
He has the cobs coming Jerry always come throughI dont see any cobs