Hey all-
I recently built a light using the 10 cob kit from Cutter. The light has two Pairui drivers powering 5 cobs each. It has been running great for the last three weeks, but today one set of cobs began flashing on and off.
I switched drivers to that set of cobs and they worked fine; no flashing. The other cobs began flashing when hooked up to that driver as well.
It seems that there is an issue with the driver, but I can't figure out what it could be. Any thoughts?
Mark from Cutter is sending me a new driver, but I would like to know what's up with this one.
Any suggestions would be appreciated.
I recently built a light using the 10 cob kit from Cutter. The light has two Pairui drivers powering 5 cobs each. It has been running great for the last three weeks, but today one set of cobs began flashing on and off.
I switched drivers to that set of cobs and they worked fine; no flashing. The other cobs began flashing when hooked up to that driver as well.
It seems that there is an issue with the driver, but I can't figure out what it could be. Any thoughts?
Mark from Cutter is sending me a new driver, but I would like to know what's up with this one.
Any suggestions would be appreciated.