Introducing CobKits.com - specializing in DIY and Citizen COBs

I'm about to wire an extension cord to my meanwell drivers. How do I keep tension off of the connectors? I don't want anything to pull apart from the weight of the wire over time
 
M3 screws 6mm length works for cob holder and reflector adaptors. The four that are drilled into the side of the heat sink are bigger not sure what size them are.
 
Don't use the 18 gauge lamp wire from lowes when you go to pull the two strands apart it rips the insulation on one wire. Cobkits is looking into getting some single solid 18 gauge wire for us to use
 
Don't use the 18 gauge lamp wire from lowes when you go to pull the two strands apart it rips the insulation on one wire. Cobkits is looking into getting some single solid 18 gauge wire for us to use

Hmm, I use 14 gauge romex for bjb holder's, it's a snug fit but it has worked better than anything else I've tried.
 
fwiw im driving into town to ship at 9pm pst so still plenty of time to get orders in today, im only semi-asleep at the wheel ;)
 
some bjbs take 1.0mm wire, most (all the ones i sell) take 0.75 and cant fit over 18 GA

I don't know what to say. I have 20 bjb holders all bought from you and 14-2 romex worked the best for me. It worked so well that when I start adding cobs next month I'll be replacing the existing wire with romex.
 
i had someone else destroy all their bjb with 14 ga (stranded i beleive)

if it grips it grips i guess. 18ga is oversized for out application to be honest

14GA would handle 15A to a cob
 
Back
Top