nc208
Well-Known Member
Looks like They have been busy over there, saw this on Gromau5 instagram, what do you all think? Pre-Orders for April 30th right now
https://chilledgrowlights.com/our-products-services/diy-led-grow-light-parts/diy-led-boards-and-heatsinks/chilled-logic-100w-pcb
This board was specifically designed to fit the RapidLED 140mm pin heatsink and acts as a enhanced COB replacement.
The 3000 kelvin base spectrum is enhanced with next gen 660nm deep red diodes for a superb flowering spectrum. While this board may be used for vegetative growth, its flowering spectrum is specifically targeted towards red & deep red levels that are not available in COBs.
At 50 watts, ChilLED Logic boasts 15% increased photon efficacy over Cree cxb3590 at 1400ma. At 100 watts, ChilLED Logic maintains an efficacy of 2.35 µmol/J chip level.
Thermal management & heat spread is excellent on the Rapid 140mm pin heatsink. It may be possible to use other heatsinks, this will be up to the user as ChilLED Tech can only verify proper fitment on the Rapid 140mm. No thermal interface material is required, however TIM can offer nominal performance gains should the user choose to apply it.
https://chilledgrowlights.com/our-products-services/diy-led-grow-light-parts/diy-led-boards-and-heatsinks/chilled-logic-100w-pcb
This board was specifically designed to fit the RapidLED 140mm pin heatsink and acts as a enhanced COB replacement.
The 3000 kelvin base spectrum is enhanced with next gen 660nm deep red diodes for a superb flowering spectrum. While this board may be used for vegetative growth, its flowering spectrum is specifically targeted towards red & deep red levels that are not available in COBs.
At 50 watts, ChilLED Logic boasts 15% increased photon efficacy over Cree cxb3590 at 1400ma. At 100 watts, ChilLED Logic maintains an efficacy of 2.35 µmol/J chip level.
Thermal management & heat spread is excellent on the Rapid 140mm pin heatsink. It may be possible to use other heatsinks, this will be up to the user as ChilLED Tech can only verify proper fitment on the Rapid 140mm. No thermal interface material is required, however TIM can offer nominal performance gains should the user choose to apply it.