Attn: cobbers please help!! Will this heatsink work?

[Greenman218]

@CobKits @welight One hole falls under the metal chip but not the les!! Is this ok or what should I fill extra 4 holes with, tim, or run extra screws in and cut heads off?? Will be pushing 85 to 100 w. Dont want to ruin my veros!

 

[CobKits]

whats that big green blob?

 

[Greenman218]

Haha one of my kids toys I just cut a peice of paper and used the toy as a weight to hold the paper from moving for example of the metal back!! Turn it inside out and set it on ground and it will pop into the air lol.There old school!

 

[Greenman218]

Here is a better picture!! Any suggestions???

 

[Greenman218]

@CobKits was looking at your site for some stranded wire and didnt see any!! Do you carry any?

 

[Olive Drab Green]

@CobKits @welight View attachment 4182729 View attachment 4182730 View attachment 4182729 One hole falls under the metal chip but not the les!! Is this ok or what should I fill extra 4 holes with, tim, or run extra screws in and cut heads off?? Will be pushing 85 to 100 w. Dont want to ruin my veros!

I don’t think you need to fill the extra utility holes.

 

[Greenman218]

I don’t think you need to fill the extra utility holes.

Thanks for the advice!! Now to figure out the spacing for these veros at 100w.

 

[Fubard]

No sense in filling in these tapped holes, chances are you would get a temperature differential there which is never a good thing and there's also the chance that the different metals would expand at different rates so your "filling" could just fall out anyway.

 

[CobKits]

@CobKits was looking at your site for some stranded wire and didnt see any!! Do you carry any?

nope. solid only. suerior for our application