must be add a heater to my bubblecloner?

[Rblade]

Hello fellas. Recently I made a bubblecloner for my cuts. But after 15 days trying it I can see that the cuts haven´t bump roots. No one. The temperature around the cuts its around 10-13ºC and the temperature of the water its around 12-14ºC. I think its a very low temperature.
I must add a heater to the water?

 

[Coalcat]

Hello fellas. Recently I made a bubblecloner for my cuts. But after 15 days trying it I can see that the cuts haven´t bump roots. No one. The temperature around the cuts its around 10-13ºC and the temperature of the water its around 12-14ºC. I think its a very low temperature.
I must add a heater to the water?

Yea a heat pad makes all the difference. I heat to about 80f or 26c using a seedling mat and a inkbird heat controller. Change out the water once a week to keep any algae growth down from any light leaks (I have a homemade one too)
Good luck.

 

[Rblade]

Yea a heat pad makes all the difference. I heat to about 80f or 26c using a seedling mat and a inkbird heat controller. Change out the water once a week to keep any algae growth down from any light leaks (I have a homemade one too)
Good luck.

thank you fella. I bougth an acuarium heater. I think that this can be make the difference