Connecting fan and filter

[hussar]

Can Filter with 6" flange and Cloudline T6.
I bought the Can Fan collar thinking I could just clasp them together but the OD of the fan is more like 5 3/4"
I was thinking to buy a roll of foam tape to build to OD of the fan up so that it would close the gap a bit. What do you guys think?
I'm not sure if 6" ducting will fit over the flange either.

 

[Matpackproduce]

They have bigger than 6”ducting, I recommend whatever size will fit

 

[JoeBlow5823]

This is what you are looking for

SUPPLY GIANT 6I4I Flexible Pvc Coupling With Stainless Steel Clamps, 6 inch, Black - - Amazon.com

SUPPLY GIANT 6I4I Flexible Pvc Coupling With Stainless Steel Clamps, 6 inch, Black - - Amazon.com

www.amazon.com

 

[Rayi]

Like Joe above says. Easy and quiet. Can get them at the big box stores in the plumbing section

 

[hussar]

This is what you are looking for

SUPPLY GIANT 6I4I Flexible Pvc Coupling With Stainless Steel Clamps, 6 inch, Black - - Amazon.com

SUPPLY GIANT 6I4I Flexible Pvc Coupling With Stainless Steel Clamps, 6 inch, Black - - Amazon.com

www.amazon.com

Yeah, that looks like it will do the trick. Thank you very much!

 

[JoeBlow5823]

Yeah, that looks like it will do the trick. Thank you very much!

Oh i grantee you it will do the trick. Hardware stores carry them too but they can actually cost a lot more than amazon a lot of the time.