MOLD wk 6 of flower

[Boofyblitzd]

Spotted mold on my buds a few hours ago and Im not sure what to do. I immediately threw an xtra fan in my grow room to lower the RH buts its not
getting below 58%.... At lights out, it will spike higher. it has a few nights up to the 70's :c

My question is, even if chop it now isnt the mold going to keep growing on the drying buds if i can't get my RH to at least low 50's?
I usually cut the whole plant and turn up-side down, but should i do branch by branch and wet trim to stop the mold?


I cracked this bud open to see if mold or rot has started in the bud but i can't tell, I've only seen mold on this one and 1 other one.... I know this shit spreads fast
so im kinda panicking 0.O

 

[AnonymousConnoisseur44]

Sorry to hear about the mold. But the beat thing you can do is to immediately remove all molded areas including what’s next to the mold. Unfortunately the only way you can stop it from spreading is to remove any signs of mold from the affected plant. Then you should keep your plants cooler than you have been. A dry area with a nice breeze will do the trick.

“CAUTION”
Be very careful to not let any of the mold touch any other part of your plant including your other plants.

GOOD LUCK

 

[Boofyblitzd]

Sorry to hear about the mold. But the beat thing you can do is to immediately remove all molded areas including what’s next to the mold. Unfortunately the only way you can stop it from spreading is to remove any signs of mold from the affected plant. Then you should keep your plants cooler than you have been. A dry area with a nice breeze will do the trick.

“CAUTION”
Be very careful to not let any of the mold touch any other part of your plant including your other plants.

GOOD LUCK

I did that for sure! And I was pretty close to chopping it all tonight but I’ll wait tomorrow and see how the temps and rh is overnight,even with 2 fans going I’m struggling to keep it below 58% (75f)