Side lights..effective?

[Alazzzar]

Anyone here experienced with side light?
Effectiveness?
Please share

 

[smokinrav]

Done right, I'm sure it would be somewhat effective, especially if power bill is no concern. But I think of the efficiency in my systems, and just don't believe you'll get the same return on investment vs. A good overhead light and a bit of training.

 

[T macc]

Yes. There's a whole vertical section here. Check it out! No overhead light

 

[klx]

It depends on your situation. Are you selling your weed? If so how much do you sell it for and how much does electricity cost? How much more yield do you get and how much extra cost for power? Not that hard to figure out really but only you know your situation.

 

[yesum]

I used to use it. If your overhead light does not penetrate the canopy fully then side lighting makes sense. I currently keep the canopy/plants real short so the side lights are not going to be needed.

 

[Alazzzar]

I used to use it. If your overhead light does not penetrate the canopy fully then side lighting makes sense. I currently keep the canopy/plants real short so the side lights are not going to be needed.

How do you maintain a wanted height on a plant?

 

[Alazzzar]

It depends on your situation. Are you selling your weed? If so how much do you sell it for and how much does electricity cost? How much more yield do you get and how much extra cost for power? Not that hard to figure out really but only you know your situation.

I’m not going to sell it mate

 

[Alazzzar]

Yes. There's a whole vertical section here. Check it out! No overhead light

Where exactly?

 

[Alazzzar]

Done right, I'm sure it would be somewhat effective, especially if power bill is no concern. But I think of the efficiency in my systems, and just don't believe you'll get the same return on investment vs. A good overhead light and a bit of training.

what type of training would you recommend?

 

[yesum]

How do you maintain a wanted height on a plant?

I use supercropping which means I bend the plant over at several points on the main stem or secondary stems if need be. I pinch and then bend the stem till it is going horizontal. Pretty soon the part above the bend line will raise up to the light and then I do it again, maybe lower or higher on the stem. Some people tie the tops down but I found that to be too messy with the plants becoming entangled with each other.

I start bending in vegetation if needed and continue all along in flower as needed. Make sure you water the plants before bending and pinch the stem till it gives or you can break off some tops. Most of the breaks will heal up and taping the break helps it mend like a splint. I use lights that are very white or blue at 5000 to 6500 Kelvin, and also keep the lights close over the plants. This reduces stretch.

 

[Alazzzar]

Fucking Noted!

 

[smokinrav]

LST supercropping ftw

 

[T macc]

Where exactly?

Vertical Growing

Growing your plants vertically

www.rollitup.org

 

[klx]

I’m not going to sell it mate

I wouldnt bother then if it was me

 

[Alazzzar]

LST supercropping ftw

I belive i did LST on this one, but I removed the strings that was holding stems down too early..

Can you see some sign of LST training?

 

[yesum]

I see some signs yes ^^ I keep all my plant at 20 inches tall or less and I grow sativas only right now. I will train or bend them daily if I need to. The plant will be going sideways if it stretches a lot, but the vertical is controlled.