PH problems

[Hetoo82]

When I transferred my plants to a larger 5-gallon pot, I put a little bit of Plant Probiotics (beneficial bacteria )under the roots
I use poting soil with pralait
All went well
But when I watered the plants with chemical fertilizer, general hydroponics flora nova grow (2ml per gallon and PH,d will at 6.30)I noticed yellowing, shrinking, and dropped vary sleepy and brown spots on the leaves.
Then I did a complete flush one of the plants and I determined the PH ratio well in the water at 6.5 and I did the flush, but I
was surprised by the run of that it was
5.8 very low

I did the flush a length of time and in different PH percentage until I reached a degree of 9.5 ( in water )
Unfortunately, the run of stabilizes at 5.80 degrees each time
The device reads the percentage of the PH high and then continues to go down to 5.80 degrees as if there is something lowering the PH percentage as if it was programmed something strange

What is the problem

 

[Darkoh69]

5.8 is’nt too low

 

[lusidghost]

5.8 is’nt too low

According to Tinder, anything under 6.0 is too low.

 

[Lordhooha]

When I transferred my plants to a larger 5-gallon pot, I put a little bit of Plant Probiotics (beneficial bacteria )under the roots
I use poting soil with pralait
All went well
But when I watered the plants with chemical fertilizer, general hydroponics flora nova grow (2ml per gallon and PH,d will at 6.30)I noticed yellowing, shrinking, and dropped vary sleepy and brown spots on the leaves.
Then I did a complete flush one of the plants and I determined the PH ratio well in the water at 6.5 and I did the flush, but I
was surprised by the run of that it was
5.8 very low

I did the flush a length of time and in different PH percentage until I reached a degree of 9.5 ( in water )
Unfortunately, the run of stabilizes at 5.80 degrees each time
The device reads the percentage of the PH high and then continues to go down to 5.80 degrees as if there is something lowering the PH percentage as if it was programmed something strange

What is the problem

Soil will buffer out where it wants just focus on what the feed is going in and be done with it. Don’t worry about run off. Set your water for 6.5 and roll. What the rest of your environment look like? temp and humidity mainly.

 

[Hetoo82]

Soil will buffer out where it wants just focus on what the feed is going in and be done with it. Don’t worry about run off. Set your water for 6.5 and roll. What the rest of your environment look like? temp and humidity mainly.

69 F / 60%

 

[NanoGadget]

69 F / 60%

69 F inside the space with the lights on? That is way too cool.

 

[hotrodharley]

Bad light but I see at least phosphorus deficiency.

 

[Hetoo82]

69 F inside the space with the lights on? That is way too cool.

I Use an air conditioning unit
Use count 8 philzon 3000 cop
How much better temperature and humidity should be done

 

[Hetoo82]

Bad light but I see at least phosphorus deficiency.

What is the preferred distance, knowing that I am using philzon 3000 cop

 

[NanoGadget]

I Use an air conditioning unit
Use count 8 philzon 3000 cop
How much better temperature and humidity should be done

Under standard HPS optimal Temps within the grow space is mid to high 70s and under modern LED that optimal temp range goes up in to the lower to mid 80s. You are slowing down growth by keeping the space that cool.