BK’s shit show

Status
Not open for further replies.

bk78

Well-Known Member
I was using clonex at first and came to the conclusion it's more important to use a fresh razor, soap off the oil from it, then sterilize with a liter. After that just tap water, and if the tap water has no chloramine in it you can use a little bit of clorox bleach.

Another good thing to do is switch the water after the first day or two, this gets rid of any plant matter that may have come off the clones. Aero clones are awesome!! I Love not needing hormones, looking forward to the root porn and nice journal man

Noted. I will write this all down. How about pump run times? I still don’t have a short cycle timer so will probably just run 24/7.
 

Nizza

Well-Known Member
Noted. I will write this all down. How about pump run times? I still don’t have a short cycle timer so will probably just run 24/7.
If you can't get a recycling timer I'd just monitor the water temps, but the running a few drops of bleach should help avoid rot.

The size of the pump and amount of water will determine how hot the rig gets. I think when I had my Aero cloner I did 1 min on 5 or 6 mins off, I use a very small bubble cloner now. The Aero cloner I made was in a 27 gallon tote so there was plenty of water to control the heat

Keeping it on a cold floor or if there is an air pump perhaps putting the pump near your air conditioner air outlet may also help with temp control

You can also find cheap dial type timers people changed the gears on from eBay or something that makes them spin super fast which is what I did, then I just figured out the pattern of what buttons on the dial to have pushed in or out to get a better pump timing
 

Nizza

Well-Known Member
I still have jars of fruit cake I harvested last December
What are your opinions of fresh vs cured smoke? I love the terps of fresh but I seem to have a smoother smoke with less phlegm from a nicely cured bud
 
Status
Not open for further replies.
Top