Panama Red Death rdwc with MarsHydro fce6500.

smokey0418

Well-Known Member
A week into flower .
Ph falls from 6.1 to 5.8 in 10-12hr. Ec steady 1.62.
The branching phenotypes stretch away while the tighter node plants thicken.
Defoliated a bunch more leaf again.
The little one is back there , it’s the little pot that could.

FD3EC388-40FD-4077-8FAC-99A933CA8E3A.jpeg
 

smokey0418

Well-Known Member
Good morning .
After achieving stabilization I realized that the water level was not dropping and leaf leaf looked a bit droopy.
So I added 5 gallons of water and lowered my ec to 1.38. Ph steady at 6 will the water going down now and perky .

093AED95-A7BA-4DF7-AB53-F035AAF7CA31.jpeg
 

smokey0418

Well-Known Member
I have gone through and trimmed off a bunch to thin it a bit.
Will dump nutes tomorrow as two week transition has elapsed.

0028F384-EBB5-4FB0-B25F-3648EADC83A5.jpeg
 

smokey0418

Well-Known Member
Good morning for these ladies. This is day 15 of flower.

Over the past 3 days I have had many of my lower branches trimmed away to try and concentrate on what’s in the top 12 inches of the canopy.

The last few times I never cleaned away so much but surely in the long run this was right decision.

Nutes changed , ro with calmag to .1 ec and then base bloom to 1.3 ec . Ph 6

Enjoy the weekend

04D811FD-C270-4331-B08C-3601A6AEF126.jpeg
 

smokey0418

Well-Known Member
Good morning.
Over the past few days I have had some work to do.
A couple males to my surprise.
So a snip here a tug and yank , channel locking the stem and most all the root mass is removed .
Definitely not what was planned but make the most of it.
Small puff balls should be on there way.
Moved my fan across the other side so that this bigger lady has some room.

Enjoy you day.

78D46E53-3A32-4217-882E-C9FC3AE89FAE.jpeg2F044638-F47F-4B01-A179-8E48A6FC46E6.jpeg
 

smokey0418

Well-Known Member
This is how those with dirt do it, just bring out here to take a look.

Most cases impossible but in the rare case.

Looks ok , get back in there to bloom well once I get that stem pull out of there.

D11427A2-9271-4E7D-AB8F-6D0F8D764DD8.jpeg
 

Kami Samurai

Well-Known Member
Very Nice. I never liked silica in hydro since it doesn’t mix well with a lot of the ferments I run. But your stems are saying it’s working. You build your RDWC system though?
 

Rurumo

Well-Known Member
It was kind of cool to see your leaves perk up when you lowered the EC. They are looking awesome man, I have a feeling this will be some killer bud.
 

smokey0418

Well-Known Member
Pretty much my entire question. What size pvc are you using? Are you having clogging problems?
I have 3 inch. The only place of issue is the return line from the t at the back. I have seen a significant reduction in flow near the end of my grow.
The waterfall in than case helps keep things moving as much as possible.
 

smokey0418

Well-Known Member
It was kind of cool to see your leaves perk up when you lowered the EC. They are looking awesome man, I have a feeling this will be some killer bud.
It really does amaze me when things are adjusted and it’s like boom , what the hey.
 

smokey0418

Well-Known Member
Pretty much my entire question. What size pvc are you using? Are you having clogging problems?
I also run two pumps , the main for flow and then a bit smaller for my falls, which is t’d and plumbed with shut offs , so that I can also use it to pump out most everything. The cc buckets are nice but too pricey with there bottom that would allow for a most 100 percent removal were I might have 2 gallons in the ribs.
 
Last edited:
Top