MarsHydro tsl2000 2x4 utility tent.

[smokey0418]

Welcome everyone to my humble abode.

I was the lucky recipient of the MarsHydro 2x4 complete tent kit.

This will be a great replacement for the 2x2 I was sporting.

I added a piece of foam insulation to keep the cement floor from affecting anything.

First job up, rooting Panama Red Death .

 

[smokey0418]

Not too much action that’s visible other than the rays in there.

Stepping next doors , 28 days from seeds cracking to 4 days into sexing.

Great structure on these fine specimens.

 

[CaliRootz88]

Looking good @smokey0418 !
I like the foam board touch since your tent sits on concrete. I noticed your hydro light is 50% on the dimmer knob for your clones. I would go as low as you can. The more light intensity you give clones the more it stresses them. They need to focus on root development with the least amount of light not photosynthesis. I used a tiny led bar rated at 8W and works great. Everything is looking great man!

 

[smokey0418]

Looking good @smokey0418 !
I like the foam board touch since your tent sits on concrete. I noticed your hydro light is 50% on the dimmer knob for your clones. I would go as low as you can. The more light intensity you give clones the more it stresses them. They need to focus on root development with the least amount of light not photosynthesis. I used a tiny led bar rated at 8W and works great. Everything is looking great man!

You are 100 percent correct on being very careful managing light.

And thank you for the reply.

The last time I rooted was using the 6500 and I set them well away.

I have two charts , one with a bit more info than the other.

Propagation and clones 150-200 and the lesser 100-300 .

Presently adjust to 200 and watching for stressing .
81.5 degrees and 100 percent humidity .

They still look good after 4 days but I just went and turn it back into the 150,s.

 

[smokey0418]

Everyone still has there poker face on.

 

[smokey0418]

Panama Red Death producing 5 nodes at 8 days into flower.

 

[smokey0418]

MarsHydro 2x4 tent kit with the Tsw2000, getting it done.

 

[smokey0418]

More roots.



And maybe a female, definitely have a few males but hoping one of the more sativa looking ones was a fem.

 

[PopAndSonGrows]

Tomato-tomahto but that's the TSL 2000 nice!

 

[smokey0418]

For regulars these are like magic , it’s a female extravaganza.

 

[smokey0418]

Even the multi nodes helicopter branching ones are female.

 

[smokey0418]

I have a few now planted in my totes, but had a run around with some earwigs , eating my new roots.
Finally catching the pricks in action but fully understanding what the problem was is beneficial to everyone.
There very determined.
All in all there doing ok , noticed a bit of a deficiency perhaps a bit low on my feed , so without delay I have turned that up to .7 ec

 

[smokey0418]

The 2x4 all in one from MarsHydro is a great setup.

Complete with the TSL2000 and 4 inch fan this does a banging job at getting these girls rooted.

 

[smokey0418]

Going through the stash , this was on the top.

No pre soak or vertical paper towel.

oasis cube ,late last Saturday night.

All 3 cracked but only one has made its way.

I am loosing hope on the others as they have not vigorously done anything after poking a tail.

Welcome Dankberry.

 

[Racky]

Welcome everyone to my humble abode.

I was the lucky recipient of the MarsHydro 2x4 complete tent kit.

This will be a great replacement for the 2x2 I was sporting.

I added a piece of foam insulation to keep the cement floor from affecting anything.

First job up, rooting Panama Red Death .


View attachment 5149578View attachment 5149579

How low did you have light for seedlings? I have the same exact set up with the tsl2000

 

[smokey0418]

I do use spoton for this but at 21 inches away with the dial in this position puts out 150 ppfd.

 

[Racky]

I do use spoton for this but at 21 inches away with the dial in this position puts out 150 ppfd.

View attachment 5191456

Thank You I have mine at 24 currently.

 

[Newcangro]

Going through the stash , this was on the top.

No pre soak or vertical paper towel.

oasis cube ,late last Saturday night.

All 3 cracked but only one has made its way.

I am loosing hope on the others as they have not vigorously done anything after poking a tail.

Welcome Dankberry.




View attachment 5191420View attachment 5191419View attachment 5191422

Have some future island that I am waiting to pop

Following along to see how these turn out

 

[smokey0418]

Have some future island that I am waiting to pop

Following along to see how these turn out

Just an update . It was going well then a couple days later , it went to hell.

The other 2 failed to get past a short tail and then the one in the picture.

Well it just failed to continue to root in the water so I transferred to promix and it has drooped , then yellowed as if over watered .

So I let it dry , leaf pics up a bit and just grows so slow.

It’s been 2.5 weeks above ground and it looks 3 days.
Terrible.
I feel bad thinking I have done something wrong and have debated purchasing more to run it.
Definitely a head scratcher.

 

[smokey0418]

Ok , don’t shoot the messenger.
Dankberry is alive and making a go for it.
I don’t see her in a position to help yet so I am working on a substitute.
It’s an Anesia product also , Future 1.