Wake n Bake, Nothing Better!
- Thread starter Chiceh
- Start date
Jeffislovinlife
Well-Known Member
Its all fun and games until someone gets a BOO BOO
Jeffislovinlife
Well-Known Member
Coffee to all may you have a great day and a better night 
manfredo
Well-Known Member
Yep, I tried the impact wrench, the dab torch, vice grips, and what I really thought was going to be the winner, a pipe wrench....A few different sizes even. Also tried pounding on the next size smaller impact socket. Nope to all.
I don't have a set of those easy outs, but the real problem is not enough room. If it was up on a lift it would be a lot easier.
I did get a really good look at my tires though, and they are shot!! As are the TPS sensors. Ugh!!
manfredo
Well-Known Member
All you need is about 3-4 days worth of cocaine and you'll see all kinds of spirits.
Did you try pounding on a metric socket?
Sometimes that works.
I will take your word for itAll you need is about 3-4 days worth of cocaine and you'll see all kinds of spirits.
Too scary for me!
BudmanTX
Well-Known Member
Morning everyone....how everyone doing this fine Thursday......
well woke up to a cool 51F this morning, from the weather reports this morning we got some heavy thunder boomer coming through tonight or tomorrow morning, it will cool us down a little more, high today 80F.....
on the truck front, i got it back, it's amazing what a pieace of rabar can do to a catalitic converter......js
well time to attack these taco's and get a warm up, just made a fresh pot.....so here we go....
well woke up to a cool 51F this morning, from the weather reports this morning we got some heavy thunder boomer coming through tonight or tomorrow morning, it will cool us down a little more, high today 80F.....
on the truck front, i got it back, it's amazing what a pieace of rabar can do to a catalitic converter......js
well time to attack these taco's and get a warm up, just made a fresh pot.....so here we go....
manfredo
Well-Known Member
I did....Sometimes I'll tap on a rusty bolt/screw with the air chisel to loosen it up, but it's an aluminum oil pan so I don't dare.
BudmanTX
Well-Known Member
got any PB penatrating oil?
Last edited:
DarkWeb
Well-Known Member
If you can weld you can also weld a clean nut onto the bad one. Then the heat and fresh nut will get it out.
raratt
Well-Known Member
Seafoam works well...
BudmanTX
Well-Known Member
i've done that here, when i break a stud off, just put the nut on top of the broken stud, and weld, 9 times out 10 it comes straight out
BudmanTX
Well-Known Member
that it does...makes a hell of a smoke screen too....
Just make sure you give it a couple of minutes to cool down & reduce it's diameter.
With a good weld on the nut most all of them will come out.
Edit: As long as it's steel on steel. Aluminum blocks & small steel studs/bolts can increase the level of difficulty here by a BUNCH!
Last edited:
RetiredToker76
Well-Known Member
How many joints should I roll for being out of the house for 7 hours?
I did some math and no matter what I'm somehow taking more than I smoke while sitting at home. Weird.
I did some math and no matter what I'm somehow taking more than I smoke while sitting at home. Weird.