they have the cloning dome with the light ive been keeping it on a heating mat and spraying themThose should be moist and covered with a dome. The ridiculously dry cubes and low humidity don't seem to be working too well.
Dunk those cubes to get them moist all the way through.they have the cloning dome with the light ive been keeping it on a heating mat and spraying them
i did i do it 2 ti,mes a day they are moist juts look like that because of pictureyeah they are too dry for sure. Hydrate those cubes, and put them under a dome.
i do all that exept for the elevate part il do that are they dead should i start overAs stated above.. dome them, and use something to elevate them from being directly on the heat mat unless you are controlling the temp. Mist the cubes, and keep them moist. Spray mist multiple times daily if needed.
i did that i also spray them cubes to keep them moist and humidity upDunk those cubes to get them moist all the way through.
I would. Make sure you are taking cuts from a healthy plant. Gives them a better chance. They don’t need a ton of light either. You could use a small desk lamp to keep them going if that’s all you had available.i do all that exept for the elevate part il do that are they dead should i start over
send me a link please thank youI found with the root riot cubes it was best to soak them in a weak veg solution .... but after trying loads of times and not having a very high percentage I bought an aero cloner and I'm around 90 percent success with one of these simply snip the cut prune the leaves set it and forget it .. best piece of kit I've ever bought
thanks i had them like that and change it up i will go back to this thanksRaise them off the heat mat a bit with some bottle caps, or a few rings from a Mason jar lid. Some of those heat mats just keep on running. Make sure the vents on the dome are open. The light built into the dome along with the heat mat are roasting your clones. Mine root just fine using the side wash from my veg lights, which are actually underneath my dome.
View attachment 5340558
Don't let them sit in water either. Just mist the cubes and the plants once or twice a day. The stems need to callous over to form roots, so it needs air as much as water
send me a link please thank you
thanksX-Stream Aeroponic Propagator 12 20 40 Site Hydroponic Propagation | eBay
PRODUCT INFORMATION.www.ebay.co.uk
They are cover with plenty of humidity this is a picture with the dome offThose should be moist and covered with a dome. The ridiculously dry cubes and low humidity don't seem to be working too well.