Harvest a Pound Every Three Weeks!

[Jagermaster]

Hey Jager! I thought I had redwoods. LOL
I chopped mine early down to about 6" tall. Since I'm close to flowering these I doubt it would be a good idea to do that. The root mass is so freaking large I can't pull the net pot out of the veg'r, so I'm gonna have to ride this one out in a crane...

For everyone else reading this... Do yourself a favor.

DON'T VEG TOO LONG!

I just ordered a second flowering HPS for my next set of girls. They're at 2 weeks now and I think I'll error on the side of too little when moving into flower.

I've clipped my first clones as well. How are you doin with your clones?

Good luck

 

[SOG]

guys, i need lil help
working on a DIY Ice Box for the main exhaust line (pics in my journal)
i need to know how hot is the air being exhausted
from 4 or 2 x 1000w HPS inside Sun Tube's
anyone running a similar layout and can pull the temps for me, greatly appreciated

 

[robotninja]

Hey bugs you are probably gonna need multiple cloners for that many, or one huge container.

I was going to post this in my journal but i thought it was a question that everybody could benefit from. I think i have some nute burn? my room temps and humidity and co2 levels are perfect so i narrowed it down to possible over fertilizing. Its only one strain out of 3 in this unit (cheese). The leaves near the top are yellow and crispy. This strain has always done this but still have always yielded great. I thought once i had my controller all the plants would stay lush until the flush, so it has to be too high a nute ppm. I know there is no way to save the affected leaves now but what is the best course of action?

should i drain and flush with clean water for a few hours then readjust the nute ppm to be lower?

Yea, that's burn man. I'v been seeing it on my plants as well. Some strains just don't need a lot of nutes. Drain and run with plain water for a hour or so, drain again and go half strength.

The affected leaves will never recover, so I chop off the really bad ones. I feel ya though, My SSH burns at anything over 1,600 ppm's! I want a strain I can run at 3k+

Say, where was the link to that thread with all the strains ppl have run in the stinkbud system? It's a good idea to document ppm lvl's for diff strains, don't want others makeing my same mistakes >

 

[grandpabear3]

i want to make a 120 instead of running 3 or 4 stink cloners. but i'm wondering if the roughnecks come that big or if there is something i can do or if any of you know of a diy 120 that works.

 

[orzz]

i want to make a 120 instead of running 3 or 4 stink cloners. but i'm wondering if the roughnecks come that big or if there is something i can do or if any of you know of a diy 120 that works.

I got frustrated trying to make an 80 site cloner and wound up buying a 70 site that was too expensive but I have trouble with my back and DIY projects.

Hope you get it done. It would be great to see how you do it. Good luck.

 

[Delusional]

i want to make a 120 instead of running 3 or 4 stink cloners. but i'm wondering if the roughnecks come that big or if there is something i can do or if any of you know of a diy 120 that works.

Saw a 32gal roughneck container at lowes last time I was there.

 

[grandpabear3]

I got frustrated trying to make an 80 site cloner and wound up buying a 70 site that was too expensive but I have trouble with my back and DIY projects.

Hope you get it done. It would be great to see how you do it. Good luck.

well, thanks buddy. if i find it. i'll do some pics. basically it will be a big ass stink cloner

Saw a 32gal roughneck container at lowes last time I was there.

i wonder if that is big enough......hmmmmm have to go see now. thanks.

 

[GanjaAL]

Lots of great pics stinbuds..love the blueberry buds..and repvip..your setup is looking bomb...Lion your room is coming together awesome! Stink thanks for spreadin the love again!

I think my upcoming harvest is gonna be my biggest and best yet! I just started the flush with sweet.

will take pics in a bit.

Hey sir... was wondering what the new regimine is... I thought we flush with clearex? Read over 400 pages so far and missed the change up...

You sir are also an inspiration to me.

Also thanks to stinkbud and all the other stinkbuddies... this is the best school one could ever have the privilage to attend.

See you guys when class is over.

 

[pinner420]

has anyone done or needed to do a 120 site cloner with stinks plans? i need a 120 and i dont wanna run 4 units, ya know?

I've learned in this game not to put all your eggs in one basket!! Build two sixties or build a 120 but make sure to get a 3 head ocean mist fogger with float for backup maybe two then you could roll one unit. If you opt for the fogger then get a fan that has a controller. If you have money skip last instruction and get a nutramist kit. http://futuregarden.com/hydroponics/systems_nutramist.html
Much Success!!

 

[jmaq5001]

that almost sound impossible man... How do you keep your PG&E from being so high that type of thing makes a difference in CA police will be kicking down the door plus the odor from all them plants will alert your neighbors and cause problems

 

[NewHiddenGrower]

that almost sound impossible man... How do you keep your PG&E from being so high that type of thing makes a difference in CA police will be kicking down the door plus the odor from all them plants will alert your neighbors and cause problems

Heard about venting to the attic with a carbon filter?

 

[NewHiddenGrower]

well, thanks buddy. if i find it. i'll do some pics. basically it will be a big ass stink cloner


i wonder if that is big enough......hmmmmm have to go see now. thanks.

yes post it here, i want to make 1 huge cloner too so i dont have to use mutiple pumps.

 

[txhomegrown]

yes post it here, i want to make 1 huge cloner too so i dont have to use mutiple pumps.

I found this, hope it helps.
http://www.rubbermaid.com/rubbermaid/product/product.jhtml?prodId=HPProd2949118

 

[cackpircings]

I have they a 3 tray system that gives me a pound every 4 weeks. It is sound and it all ebb and flow scrog system. I have 2 600 watt HPS 8" cool tubes that I flower under, and then I have a cool hood 400 watt MH that I veg under. I have 2 monthers and do 12 plants a table. It is easy, and if you want to know more check out my grow link.

 

[DIRTHAWKER]

Yea, that's burn man. I'v been seeing it on my plants as well. Some strains just don't need a lot of nutes. Drain and run with plain water for a hour or so, drain again and go half strength.

The affected leaves will never recover, so I chop off the really bad ones. I feel ya though, My SSH burns at anything over 1,600 ppm's! I want a strain I can run at 3k+

Say, where was the link to that thread with all the strains ppl have run in the stinkbud system? It's a good idea to document ppm lvl's for diff strains, don't want others makeing my same mistakes >

Thanks Ninja..i will do that... Ive run this cheese from the beggining, its always yellowed and i always thought it was something to do with the room temps or something but now that i have a controller i know now its the nute regimen....it still is the best yielder!
The stink system strain thread is in the hydro/aero section. thanks again

 

[jnyce1320]

Hey Stink and StinkBuddys. Im planning on running this system but with only 2 flower units, 4 weeks each totaling 8 weeks flower time. Ive already built 2 veg units (1 of which i will be using for cloneing in the future) to grow some of my auto strain seeds which i have from my past soil growns untill i can afford my complete setup. Questions....

1. Im wondering which strains would be suitable for my 8 week flower setup. So far Im looking at L.S.D., Violator Kush, Hindu Kush, Aurora Indica, Ak-48, Blue Cheese, Ice, and Chronic. I would like to narrow it down to 4 stains though. Im really looking for strains that will yield an ounce per plant even without CO2.

2. Im planning on growing in 2 tents. 1 for veg/clone 4'x4'x8' and one for flower76"x76"x76". My biggest problem is that I want to keep the room sealed. I do have central air so I want to kep elec cost low as possible. When running A/C to keep grow room temps down the other rooms in my house are freezing cold. Should i run ducting directly to my tents so i can raise thermostat temps alittle or should invest in a portable a/c unit to put inside the flower tent atleast.

* Right now i have a 4x4x8 tent that has 2 of the veg units growing my auto strains. Cooltube is ducted to exhaust fan to exhaust air from the tent.
There is a 5-10 degree diffrence from air outside the tent and air inside the tent. But growing Stinks Aero setup im planning on having the the reflectors sealed/air blowing threw not exhausting the air so i could run CO2 but will make tent temps hotter.
With central air set to 69deg and exhaust fan on, Tent temp 74-78deg, Humid 30-35%. Without exhaust fan 79-84deg, Humid 40-45%. Temps can soar 85-95deg without A/C and its not even summer yet. Do you guys think I may need to invest in a bigger humidifier or swamp cooler maybe?
Sorry for blabing on i just want to give you guys as much info as possible

 

[DIRTHAWKER]

Hey sir... was wondering what the new regimine is... I thought we flush with clearex? Read over 400 pages so far and missed the change up...

You sir are also an inspiration to me.

Also thanks to stinkbud and all the other stinkbuddies... this is the best school one could ever have the privilage to attend.

See you guys when class is over.

Thanks Ganjal... yea stink is always trying new things and recently switched from flushing with clearex to sweet, instead of a 14 day clearex flush we do a 5-7 day sweet flush..this gives extra time for growth and the buds taste incredible!

hope that helps...happy growin!

 

[Aeroweed]

Thanks Ninja..i will do that... Ive run this cheese from the beggining, its always yellowed and i always thought it was something to do with the room temps or something but now that i have a controller i know now its the nute regimen....it still is the best yielder!
The stink system strain thread is in the hydro/aero section. thanks again

Awesome Dirt
Thats great to hear about the cheese being the best yielder. I have 6 UK Cheese...

Please post to the strain thread, so I know what to do with mine!

 

[andyman]

Saw a 32gal roughneck container at lowes last time I was there.

I did a 32 gal roughneck for a friend and it worked fine. it was only able to hold 80 and they were way tight and lacking room, but its still being used and did the job

 

[NewHiddenGrower]

ill get that 45 it can fit 80 no prob




Hey guys its my first time cloning and im getting nervous... check out some pics

i have total of 48 cloning And one avocado seed germinating






In this picture you cant see if it but some leaves are actually curling up and turning black!