Harvest a Pound Every Three Weeks!

dagobaker

Well-Known Member
no
im growing out a hybrid from a friend called strawberry diesel x og kush.....so i have one in flower in the greenhouse and a few clones in the stink bud mix in veg
 

whysohigh

Well-Known Member
how tall is everyones girls gettin before they go into flower? im going between 2 and 3 feet, but the ones closer to 2ft are topped a bunch. what do you guys get?
 

hehehemann

Well-Known Member
Mine go in at about 14 inches. Anything taller and the plants get too big for the height of my room (lights highest point is 5ft from ground level). It also depends on the strain, sativa or indica?. I use kush strains so they are short and stocky looking and don't get too tall.
 

haikubutthead

Active Member
just completed and loaded up my newest aero grow room
this is half of the room and ill be working on the second half in a week when my clones will be a bit bigger
this is 18 plants.....9 on each side under a P&L 600 hps lighting system
my goal would be about an 1.25 oz each plant or a gram per watt
there is no co2 but ill be adding that eventually
Dago how is the coverage with your 600w. What would you say is the largest coverage (still good quality) one could expect from 600w? I am going with 6' rails and two (maybe three) rails per reservoir. Not sure about the light coverage though. Maybe I need a 1K. Maybe more?
 
Hey Dagobaker,

I'm planning something similar to what you've just done...
I want to do three 4-hole flower units, 4 in veg, 4 clones.
I'm gonna use a 1k watt hps for flowering.
I was wondering, how long do you let yours veg? And what is P&L?
Also, since I'll be running one pump per 4-hole post...I'll need 200gph each, right?

THANKS MAN,

I've learned SO much just reading here, and I'm ready to get to work.
 

DubB83

Well-Known Member
Do you have a light mover or more than just one HID in there? Is that electrical tape holding the PVC together?

~GG420

 

dagobaker

Well-Known Member
Hey Dagobaker,

I'm planning something similar to what you've just done...
I want to do three 4-hole flower units, 4 in veg, 4 clones.
I'm gonna use a 1k watt hps for flowering.
I was wondering, how long do you let yours veg? And what is P&L?
Also, since I'll be running one pump per 4-hole post...I'll need 200gph each, right?

THANKS MAN,

I've learned SO much just reading here, and I'm ready to get to work.
P and l is a top notch light brand...very high end.....the best.......the dutch use them......
one mister needs 20 gph.......so 396 gph pump means 20 misters.......200 is 10 misters
i have 18 plants under the 600 hps
 

dagobaker

Well-Known Member
Dago how is the coverage with your 600w. What would you say is the largest coverage (still good quality) one could expect from 600w? I am going with 6' rails and two (maybe three) rails per reservoir. Not sure about the light coverage though. Maybe I need a 1K. Maybe more?
i personally wont go more than 4 foot deep and 4.5 foot wide for a 600 hps......u lose coverage
i yielded 2.06 grams per watt at that coverage
6 foot long is too long for a 600.......unless ur on a mover and then u MIGHT be ok
im going to be using 2 400 hps on a mover for my 6 foot long rails and 3 foot deep...seems perfect
 

dagobaker

Well-Known Member
Do you have a light mover or more than just one HID in there? Is that electrical tape holding the PVC together?

~GG420

my light mover is going to be for my 6 foot long by 3 foot wide grow room area..using 2 400 hps on a mover
its duct tape
i cant glue......house is too tight to move around with the system all together
 
Hi guys I have a question i am planning on running this system with a switchable 1000 watt ballast and bulb so my question is should i flower with the hps bulb or just run the MH allthey way thru I swear i read somewhere that if Stink had only 1 light he would run the MH only. I have both bulbs and a switchable ballast but I want to know since im only running 1 light should i stick with the MH only or switch over to the hps when i go to 12 12
 
P and l is a top notch light brand...very high end.....the best.......the dutch use them......
one mister needs 20 gph.......so 396 gph pump means 20 misters.......200 is 10 misters
i have 18 plants under the 600 hps
Cool man,
I'm thinking 8 misters per 4-hole post should suffice? And do you let 'em veg longer with your new setup or still do 3 weeks?

Thanx again bro.
 

That 5hit

Well-Known Member
can someone pm me a list of items like how many tubes and elbo junts that i need to make just one of the systems in that picture above
for the internal sprayer and the external stand really just the inside sprayer because i can think of something else to set the table on
but tell both if you can with detail like lenth size and how many
 

Shrike

Well-Known Member
You can find what you want on page 75 of this thread. And if you want to catch up on all the great extra info that has come about because of this thread, you can d/l a pdf that has the whole thread in it. I update it every 100 pages...the link is in my sig.

can someone pm me a list of items like how many tubes and elbo junts that i need to make just one of the systems in that picture above
for the internal sprayer and the external stand really just the inside sprayer because i can think of something else to set the table on
but tell both if you can with detail like lenth size and how many
 
Top