How Do I Make Hash??

ViRedd

New Member
I wouldn't use males for hash making. Not enough tricomes, so it would be a big waste of energy in my honest opinion.

Vi
 

shhimhiding....

Active Member
vi you may be right....besides they may be males but they r mad crystally...just read your butter recipie...i work in resturant....hmmm....eyes gon make sum butta!!!
 

ViRedd

New Member
Wait a sec ... if they are all full of crystals, are you sure they're males?

How about doing this: Take some leaves that look like they have crystals on them. Put them in a small envelope and stick it in the microwave. Turn on high for 20 seconds. Turn the envelope over and do another 20 seconds. Keep doing that until the leaves are dry. Now, crumble them up, put them into your pipe and take some hits. If you get a nice buzz ... proceed with the cookie baking. *lol*

Vi
 

FlshN2gear

Active Member
By hash do you mean hash resin made from seeds and stems or shake? If you do that is a fairly simple process of soaking a THC concentrated part of the plant in isopropyl Alchohol (they say 99% works best but I've made some pretty kick ass hash with 91%).

After soaking and shaking ur alcohol and bud, take a coffee filter and poke holes in it with a pin only a few centimeters apart from one another. Take ur filter and fasten it around the end of your container, I like to use one of those jars with the break-apart lids so at this point i can replace the metal lid plate with the filter. Now drain the alchohol through the filter (it should be dark green and thicker now) into another container. Repeat this process of soaking and draining until the alcohol no longer becomes green.

The seeds and stems or whatever bud used are now trash. I imagine if you let the bud really, really dry it might be smokeable but the effects would be minimal as the majority of the THC is now extracted into the alcohol. This is why the alcohol now needs to be evaporated out of the mixture. To do this rinse your jar of any solid waste left from your bud. Now pour the alcohol-resin mixture back into the jar, leaving the lid off. Fill a pot a little less than half full with water and set the hash jar in the water (pour out water until it sits flat in the pot if it floats). Place all of this on medium-hot heat or until the water bubble slightly as well as the alcohol.

Since 91% alcohol is extremely flamable you will need to be very careful here not to spill any on the burner. The water in the pot will keep the alcohol from heating to quickly and igniting. The water will also create a drip buffer for any alcohol that might escape the jar, even so I urge extreme cation when cooking this

Depending on how much liquid you have will determine the cooking time. I fill the jar 3 or so inches from the top and boil it for 3-5 hours. After all of the alcohol is evaporated and the mixture is completely dry you will be left with dark green (practically black) resin. The stickiness of the product seems to vary perhaps with the amout of fresh bud used but you should be able to scrape the hash with a spoon to be smoked. The final product should be dry enough to smoke directly out of any pipe and potent enough to make you forget your holding a pipe after two hits. This is great to smoke as a supplement to shwag, it increases your high quite pleasantly. I hope this helped someone. Enjoy!:peace:
 

Vote 2 Legalize Marijuana

Well-Known Member
Bubble hash bags 4 sure! Or take a shit load of buds like I do. The resin is collected by carefully rubbing the buds between both hands. Later the collected resin is pressed to homogenous Hash-sticks.


 

nongreenthumb

Well-Known Member
Why waste all that green for such a little bit of hash, hash here in england is 40 for an ounce which is about 60 dollars, white widow for an ounce is 130. I have no doubt the widow hash will get you bolloxed but the amount of weed he used to do it.
 

Terry_Tokabolla

Active Member
Please doing warm alcohol on the stove!

I just throw my keif in a blender... get it buzzed up a little. In a jar put a good handful of shake in it with an equal part isoprophyl 99%. Shake the fuc8 out of it for a minute then strain through a coffee filter into a pyrex dish.

Let the alcohol evaporate for a few days.. (the more the better).

Now scrape that residue out and it'll knock you on your ass! (well... don't know about doing it with males... but the females make some killer iso-hash)

Its more like oil tasting than hash... it's very sticky and messy. works good spread on papers or bottle toked.

I have yet to learn to make that yummy hash I usta get back in highschool. Haven't even seen any good stuff in many years. That video looks pretty close! (but... not like them QP's I used to get! how do they make that! ... it was like a nice cigarrette pack size chunk - not that puny piece)
 

MajoR_TokE

Well-Known Member
Haven't even seen any good stuff in many years. That video looks pretty close! (but... not like them QP's I used to get! how do they make that! ... it was like a nice cigarrette pack size chunk - not that puny piece)
If you didn't notice he made that hash using only his clippings/shake or wheatever.. If you used good poduct or more clippings/shake you would end up with more hash!
 

MajoR_TokE

Well-Known Member
Please doing warm alcohol on the stove!

I just throw my keif in a blender... get it buzzed up a little. In a jar put a good handful of shake in it with an equal part isoprophyl 99%. Shake the fuc8 out of it for a minute then strain through a coffee filter into a pyrex dish.

Let the alcohol evaporate for a few days.. (the more the better).

Now scrape that residue out and it'll knock you on your ass! (well... don't know about doing it with males... but the females make some killer iso-hash)

Its more like oil tasting than hash... it's very sticky and messy. works good spread on papers or bottle toked.
That kinda sounds like oil to me..
 
Top