Balls to the Wall grow, Riddleme Gets Serious

Vento

Well-Known Member
Been waiting for this ... how i managed to miss it this far i have no idea :)

Good Luck Riddle ... lets see how this all works out .... I'm looking forward to following this and picking up lots of tips and exploring lots of experiments along the way :)

Subbed ...Hook... Line ...sinker ... rod ... fisherman ..peer ......
 

riddleme

Well-Known Member
you don't have to thank me

looking at the babies this morning I now see the same little heads popping that I saw on the 1st one yesterday so all 4 are going pic's again once we have coty's :)
 

riddleme

Well-Known Member
I just took some pic's to make a point in a thread where they were asking how far a 400 watter should be from the canopy

I thought I would share them here as well so you can all see them

As I stated in the thread my light is 4 and 1/2 feet above the seedlings and they are gettin 5000 lumens
 

gumball

Well-Known Member
Just for arguments sake on the last post. Would you put up something to similate the canopy so we can see the lumens as the bottom branches would see them? Like you did with the overcast sunlight and full sunlight.
 

riddleme

Well-Known Member
Just for arguments sake on the last post. Would you put up something to similate the canopy so we can see the lumens as the bottom branches would see them? Like you did with the overcast sunlight and full sunlight.
Not sure I have anything at the moment, but will see what I can do

I planned on taking these kind of pics through out the grow so for sure will be able to see once it gets going
 

riddleme

Well-Known Member
Ok put one of the ol lady's plants down there and the lumen count is cut in half, but please note that all of this is 15 inches below where the bottom of the canopy will be once they are in the 5 gallon pots

took a close up of the light sensor so you could see I put leaves over it
 

Attachments

gumball

Well-Known Member
So that's close to the 3000 lumens per sq ft that some peolpe use as a guide. not that I use that as a guide, since matilda and some of sicc's party cups I am not so concerned with super high output lights and what not. Just enough light so the plants do well.
 

gumball

Well-Known Member
I just remembered you got that new camera right before you harvested tilda! Finally getting to put it to good use along with the CMH!! Looks awesome!
 

riddleme

Well-Known Member
well got the secret experiment all set up and ready

and to see if you can guess here is your first clue (pic)

it is a digital thermostat (you can get em at wal-mart for like $24) hooked to a 12 volt 10 amp relay and that is wired to a 12 volt pwr supply,,,,,so basically this is a switch that is controlled by temperature and can turn on a 10 amp device

any guesses???
 

Attachments

Illumination

New Member
well got the secret experiment all set up and ready

and to see if you can guess here is your first clue (pic)

it is a digital thermostat (you can get em at wal-mart for like $24) hooked to a 12 volt 10 amp relay and that is wired to a 12 volt pwr supply,,,,,so basically this is a switch that is controlled by temperature and can turn on a 10 amp device

any guesses???
Temp controlled switch for an infrared light/heat source?:joint:

Namaste':eyesmoke:
"A state licensed personal medical grow...Thank you":peace:
 

cowboylogic

Well-Known Member
well got the secret experiment all set up and ready

and to see if you can guess here is your first clue (pic)

it is a digital thermostat (you can get em at wal-mart for like $24) hooked to a 12 volt 10 amp relay and that is wired to a 12 volt pwr supply,,,,,so basically this is a switch that is controlled by temperature and can turn on a 10 amp device

any guesses???[/QUOTE}
EDIT: My stoned ass needed to rewrite this! It will control your computer fans near the floor of you grow area. Turning them on and off when triggered by heat from the burner on your gas water heater. Moving CO2 rich air through the grow area. How is that for a guess. LOL
 
Top