$$ my WM aero bubbler cloning machine $$

[moezers]

BIGMIKE, thank you!!~

 

[BIGMIKE13]

BIGMIKE, thank you!!~

your welcome....

hope this will help you!!

 

[youngpizzle]

I plan on building something based on this same design, how big should the airstones be? And how many do I need for a 14 gallon tub?

 

[BIGMIKE13]

just do a trial run and make sure your getting water to were you will have your cuttings.

 

[youngpizzle]

Do u think 2 6" airstones would be enough??????

 

[yovickwilly]

Do The Cutting Sit In The Water ?

 

[mrduke]

this is just what i've been lookin for +rep for bigmike

 

[Tronica]

I have a question about where you take your cuttings. You say you have a high success rate. What hormone do you use? Where do you cut from? Lower or higher on the plant? Do you leave 1 node below the tray level? What kind of scaring do you use? What do you use to cut with and how sterile are your tools? I have design and water temp down, and I got roots on 2/3 cuttins I just took and tossed the third. It took a long time and I have more in my bubbler now. I need some help on perfecting my cuts.

 

[rayjunyor]

hey man that's funny i tried clone with rockwool and clonex 5 times no sucess, no roots or sometime roots and die later...now im looking for dwc cloning tipe...im just scare after the clone get roots how do i put them int he roockwool, because for flowering stage i use Ebb/flow system ...any help i would appreciate

 

[Ace16vip]

Big Mike...I have a DWC tub similar to what you have...but I have net pots and also using rockwool for the seedlings...how far would you say to the water should be from the net pot???

 

[mysunnyboy]

bump for big mike