Tenner
Well-Known Member
You can look up "The Machine" online and make one yourself. My machine was made out of a 75cl Jack Daniels bottle, with a hole drilled on the bottom of the bottle with a concrete drill bit. The hole on the bottom is your inhaling hole and should be at least 4mm in diameter, just like pencil size or something should do.Sorry I am new to this can you explain farther. Thanks
Now thats the hardest part done, get some steel wool used for dishes (not the very thin type, the bristly one) and as a precaution hold it with some tongs or pliers and heat it up with a normal lighter or some sort of flame for a minute to make sure no plastic coating was used on it (you dont want to be smoking teflon lol)
Now put an amount of the steel wool in the mouth of the bottle like a stopper say an inch long. The machine is ready!!
You sprinkle your elf spice on the steel wool, lie down comfortably and put the bottom of the bottle on your lips (where the hole you drilled is located). You then use a lighter (like a clipper) and apply heat to the steel wool but AVOID THE FLAME TOUCHING THE WOOL!!!! Its not rocket science but you don`t want to lose your valuable spice! Sort of light the lighter, bring it close to the stopper and inhale so the flame bends towards the stopper and ur sucking in the heat with little or no contact with the flame itself. Try without spice to understand how your going to do this. I usually let the flame touch slightly towards the end to get the spice on the bottom of the stopper.
I`m making it sound hard I think but its the easiest and most comfortable way of smoking DMT. The bottle will fill up with vapour, one big hit and ur down in wonderland No harshness on the throat, can`t even taste the stuff until u exhale.
Oh and if there was coating on the steel wool just keep heating it and brushing it or washing up with it or something, we arent going to heat it too much for the vape anyways so its ok.
And assuming the reader has no knowledge of drill bits, the drill I used was a simple concrete drill, the ones which have a silver body and a V shaped HSS (high stability steel) on the tip which is often painted red. It takes a while to drill and you should apply small amounts of water.
I remember reading someone heating the bottom of a bottle with a lighter and just applying cold water, cracking a hole through without the usage of a drill but I have never tried it as I`ve always had drills around. Maybe a nice thwack with a nail or chisel would do? Make sure there is no loose glass pieces when its ready!
With the machine its first try first fly Have fun!!