Clones and flowering in same room?

bratattack

bratattack

Active Member
If I put a shelf halfway up in a closet, and blocked out light, would it be possible to have the lower half of a closet used for veg and the upper half of the closet used for flowering? The bottom shelf would be using t5 fluorescents so there would not be much heat, and the top would use either an hps or LED.

I think that done this way properly blocking light leaks to the top shelf, I could turn one closet into both veg and flowering chambers by utilizing the height of the closet. What do you think?
 
Ringsixty

Ringsixty

Well-Known Member
yep..i see no problem as long as there is no light leak to the flower side. good thinking to place the flowering on top...heat rises;-)
when done post pictures
 
F

F A B

New Member
bratattack said:
If I put a shelf halfway up in a closet, and blocked out light, would it be possible to have the lower half of a closet used for veg and the upper half of the closet used for flowering? The bottom shelf would be using t5 fluorescents so there would not be much heat, and the top would use either an hps or LED.

I think that done this way properly blocking light leaks to the top shelf, I could turn one closet into both veg and flowering chambers by utilizing the height of the closet. What do you think?
Click to expand...
thats same thing i did made a room inside a room veg below flower above but i ran out of room so just turned whole area into veg and built a separate flower room
with proper light traps and sealing all light leaks u can do it
 
bratattack

bratattack

Active Member
think separation with panda film would work? maybe a second zipper for the top chamber? perhaps a duct from bottom to top chamber for exhaust?
 
bratattack

bratattack

Active Member
what's the plywood do? do you run 2 exhausts then? I'm thinkin of adding a plywood shelf then light sealing with panda film and then figuring out a way to make a door or zipper tarp for the second area. Right now it's a big thing of panda film over the doorway with a zipper in it and that keeps the light in. How did you make your hinged door I can't really tell from the picture. That sounds like the best idea for the bottom chamber since it's not that easy to get the panda film to seal light unless I spend time tucking it over when it hits the floor, but it would work fine for the top chamber.
 
F

F A B

New Member
bratattack said:
what's the plywood do? do you run 2 exhausts then? I'm thinkin of adding a plywood shelf then light sealing with panda film and then figuring out a way to make a door or zipper tarp for the second area. Right now it's a big thing of panda film over the doorway with a zipper in it and that keeps the light in. How did you make your hinged door I can't really tell from the picture. That sounds like the best idea for the bottom chamber since it's not that easy to get the panda film to seal light unless I spend time tucking it over when it hits the floor, but it would work fine for the top chamber.
Click to expand...

i used plywood for top and sides of lower box vented into the bigger room but should have made it vent outside separately cuz it just added more heat
 
You must log in or register to reply here.
Top