Great!
I like it!
how different would it be to put the fittngs on the cooler? With the thick walls...
Not hard u drill straight thru.. Only need to grommet the inside.. I actually built one but drilled my return to close to the bottom and scrapped it. Long as u give it enuff room from the bottom for the grommet to properly seat.
do you have a handy break down of your parts, since we are doing the same number of buckets...
I will get that for u but I think I broke the parts list down in my simple rdwc thread I'll see if I can copy n paste it for u.
i guess the drain could be the return, and the pump can sit in the cooler with the hose just going out the top... Right?!? So no need to drilll the cooler...
U could actually sit the pump on top of the cooler and pull the water thru the tube like so and push back down to ur buckets keeping the pump outta the water and cooler will keep it all cooler.
and if I understand right, it goes from the pump to the buckets through the "t"s and also another hose on the right of the pic?
Yes pulls from the controller red and pushes straight thru the loop on t's back to the controller is where its all "inline" push pull on the same pump less heat than 2 pumps..
why not just go one to the other, in line? Cause if it clogs it will flood? Prolly eh?!?