First time dwc/hydro. Whitewidowxbigbud

Welcome, as the title states its my first time in dwc the first time was a complete failure and didnt use any meters so i now understand i little bit more about what it takes. Anyways seeds just sprouted a few days ago here is what im working with


LIGHTS:
1 400W MH XTRASUN ballast and reflector (glass shield type) 8 inch fan , 1- 120w led light , 4 32w cfl . and a 1k light if need be later but its summer time and don't want to stress the girls out

STRAIN: ATTITUDE seeds WHITE WIDOW X BIG BUD

NUTRIENTS
DYNA-GROW, DYNA BLOOM, CAL-MAG gh , PROTECKT , some soluble myco, and veg and bloom to start with since its easier to monitor ppm.

ANY COMMENTS OR SUGGESTIONS WOULD BE GREATLY APPRECIATED :) thanks in advance everyone :)
 
well mine is much younger barely has the first two leaves on there :( is all hope lost? if so i just put my last bean into a moist paper towel. so im guessing a damping off problem is hard to bounce back from?
 
in lighter news check out my beast grow that is to heavy to be supported by a tooth pick..... im hoping to yield somewhere around 1045 g but id be happy with a lb dry .
 
Yo lets see that pounder beast grow! Pics?
...... ITS THE ONE BEFORE YOUR POST . sorry to get your hopes up i was trying to make myself feel better after i lost one of the girls.. its the one on the fork ... i am aiming at monsters this year bothindo and outdoor. out im doing hydro and dirt. so well see waiting on a camera
.
 

PetFlora

Well-Known Member
Lots of reasons for stems too long- lights too far away, wrong nutes, RH, ambient temps, lack of silica...

I have used small net pots, turn upside down, cut the center of the bottom out, make ONE cut down the side so you can open it once the stem gets strong.

Also, not a fan of hydroton

Check out my thread for ideas
 
Top