hellraizer30
Rebel From The North
Take the cover off that pump and turn it inlet side down, it will stop sucking airIn the pic you see i set the pump on its side, that didnt do any different than having it upright on the suction cups. Either way when the drain cycle is about finished and the water level gets to like 2" - 2.5" it sounds like its running mostly air thru it with a SMALL amount of water but it doesnt get it low enough for the bottom float switch to shut it off. So basically its going to run til it burns out. Do i need a different pump? Im thinking about remaking the control bucket and just using 1" drilled hole with 3/4" grommets for the fill/drain holes like i did on the planters, instead of those bulkheads that obviously sit up a little higher than the planter bucket holes... It kind of has to go UPHILL to get into the control bucket a little. i dunno, i need some advice please and thank you!!
View attachment 2763326View attachment 2763327View attachment 2763328View attachment 2763329View attachment 2763330View attachment 2763331
Main problem, water level doesnt get low enuf to shut of the pump..