Search results

Can you put them outside somewhere low key to flower??

How far into flower are they bursto?

Just get a 315 cmh more expensive initial cost but will be cheaper in the long run not having to upgrade and save power from day 1!? Same light through veg and flower Too :cool:

I did the same but a bit earlier, maybe 2 weeks after flower, mainly because I had to water too often. I was surprised to see how much thicker/bushier she got! Will definitely yield more from it. :cool:

Yea, I’ve had a good look at the VPD chart ozy and found I wasn’t far off it. I looked at it every now and then as a guide. It is good! Yes humidity down during lights off is important. I was reading up a while ago about lights off temps and theirs some commercial growers that drop lights off...

Should be fine then Venus! :cool:

I use a co2 burner so for me it’s just a matter of how far to bring humidity down.

I’ve grown money maker! Frooosty! Was a freebie, made a couple of simple fuckups when growing it so I put that down to why it didn’t yield much? Simple dwc outside with an air pump. Had them in an old empty above ground pool to hide them a little lol. Days were getting cooler so I was lucky to...

Yea you’ll be right. If you find their drinking way too much then up the humidity a tad.

If you want my opinion Luke (too bad if you don’t, your gonna get it haha) Your pretty much spot on, you could lift your humidity a little more and slowly reduce it as your buds get bigger/more dense. I’ve run this exact temp/humidity throughout most of flower with 1250ppm of co2 and plants...

Perfect for co2. Not sure about the led side of things but with hids you really want a minimum of 600w hps/mh. Are you going to be using a co2 generator or co2 bottle?? Just that the generators add a lot of heat and humidity.....

That’s a skunk no.1 cross? That’s skunk no.1 in my avatar grew some outdoors in dwc lol. (Along with some other strains) Around this time last year so it flowered as soon as it was mature and yielded about 2.5 ounces off memory with next to no veg time! Awesome outdoor strain with even better...

A mixture of both worked well for me, I ran 3 inline 600s close enough to slightly overlap each other. Hps on either end and mh in the middle. Over a 3.2m long scrog. Worked a treat!

Didn’t know that Reza, May be part of the reason my plants always looked a bit happier with mh or mh supplementation!?

Don’t quote me on this but a 600w mh gives something like 90,000 lumens and I’m pretty sure a 600w hps gives something like 130,000 lumens!? Hps gives off more light but at a different spectrum.

Within reason, the extra co2 allows the plant to process more light. Without sufficient lighting you won’t be utilising the extra co2 being dosed. You also need to get temps up 2 or 3 degrees more than you usually would. The plants will need slightly stronger ppm in feed. Watch how much they...

sorry, should of explained it better, yea on the outside of either side of plants and running string line through the lot? Just a little support without going too crazy..

I had the same thing happen to me a couple of weeks ago. My outdoor plants you see in the photo above are in 100% coco. You have to be careful in coco as you will deplete the coco of calcium very quickly. I used straight water for a few waterings, ensuring NOT to water till runoff (as you won’t...

I’ve run straight mh all the way from veg to flower and the same with hps. I found my yield went up slightly having a mix of both in flower and quality seemed a bit better. Also the mh only seemed to prevent plants over stretching even though there are less lumens in a mh compared to hps I put...

I might knock half a dozen posts in at each end and run string line through for a little support if we get anymore decent wind...?