Search results

no help so far eh. you started them in too strong of a soil mix. is guess generally your top layer of soil has little nutrient, idk. dont transplant, keep nursting them along. dont over water. next time start it off in a basic seed starting mix and let them grow a few nodes before the good soil

Left them unattended a few days

This lady/dude looked fucked up from the start but that's cool isn't it? Coming along now , could do better with better caretaker. Oh well. Any thoughts?

Took a pic of the fire Got a reflection of inside the trailer lights too.

https://www.weedworldmagazine.org/2017/06/28/grow-faster-with-long-light-cycles-written-by-professor-lee/ Apparently it works if you go 12/12 to start the flower off then continue 24/12, one day will be 48hrs light on with a 7 day timer.

Yeah with the 2 shelves and low hanging height the lower wattage may be enough

You multiply your volts by your amps. About 50 volts x 0.700 amps = 35 watts. The v1 288 at 700ma is less than 50 volts. Close but not the 40 you want. If you add a third board on that driver it won't work as you will exceed the volt range.

Hlg 80h 48a would get closer to 40w per board

Shouldn't shatter be decarbed by the time it's converted? I can't see why your method wouldn't work with the hash

You can mix 4 boards 2 being new 2 old ( varying voltage) by mixing and old and new In series and repeating the same with the other two, then parallel the sets. Better than adding two new in series parallel to two old in series.

Wlee mate your cat went down like a Goldfish. I'll send my prayers

Found a little souvenir after work today Anyone know what it is?

Got the urge to post mine asking what it is too Looks a lot like yours, could be the same

I broke a tab off one of my boards so I soldered to the board. works

2 oz ish for a full jar of dense nugs

Under the electrical charachteristics

Eb3slim insulation is rated for 60v probably better to use CV driver's. Would be good to check eb2 datasheet make sure your within the range.

Hey mate. Nice pull ties

Volt x amp = watt . You have two 54 v boards running at 1050ma (1.05a) If you wired in series you’ll have 2*54v*1.05a Sounds like you want the 240h-c2100