Search results

Can you mount the slim duct unit in an adjacent room and duct to and from the room?

https://www.amazon.com/Lutron-LUT-MLC/dp/B01E9F084E Take a look at these. I had issues with basement LEDs doing this. The electrical wholesaler gave me these to fix it. Note that I never ended up installing them as I sold the house. Still not sure if it was to be placed between the line and...

After a successful harvest I've decided to make some upgrades. As well, I would like to make my job a little easier (Hopefully).

Personally I like to drink about 4-6 beers first. If you smoke cigarettes make sure you have lots on hand as you will be smoking like a chimney.

Just wanted to share my clone dome build. I found standard trays and domes to be a little frustrating, the height is limited and I don't like how the edges typically taper inwards which would grab leaves of clones around the edges. Not really big issue but I like building stuff like this...

Search "headmaster control" a qualified refrig guy should know what it is when asked about it, and know how to install it.

Update: day 59, Lowered light intensity Drop day temps to 75F Night temps 70F RH 48-55% Lighter feeding around 600-700 PPM

Didn't read all the replies but a Belimo SGA24 may be useful, it outputs an adjustable 0-10 vdc signal. It has an input that will overide the output to 10 vdc.

Power up the condenser but do not enable cooling. There is a crankcase heater on the compressor that needs to warm up the oil in the system prior to starting it.

Paint?

Thank you. And thanks to everyone else as well.

Mine is a single 20x8 room that is framed. I think you would have a very hard time dialing in the temperatures inside your tents especially if each tent was at different stages. Unless you wanted to overcool the outside and add heat in each tent.

Weeks 1-4 of flower I ran these temps and even higher humidity (70-75) growth was amazing.

I use 4 x gavita 1700e which are higher wattage and a 24000 btu Samsung split. Never had an issue. How do you plan to cool inside the tents if they are sealed?

Hi all, I don't know the details of this strain. This is my first indoor grow so I'm looking for any comments from someone more experienced. Im just about to start week 7 of 12/12. Was planning to feed light this week followed by 1.5-2 weeks flush. As well, dropping co2, temp and humidity over...

My room is a sealed 8x20 with 4 gavita 1700s. 2 tons is plenty for it. Don't forget about dehumidifiers, you will need them.

Yes, like most of my home renovations that last step might take a while (baseboards!!!). Will get around to it one day. Next run I will cover the table in puck board as well so I don't have to worry about tearing the poly.

The t handle on the end of the one pipe makes it effortless to roll.

Pipe is 1" schedule 40 sprinkler pipe. Stops can be seen in the second picture. The tote underneath acts as a sump basin to collect runoff, ac condensate and dehumidifier water. It has a small sump pump in it to pump water through a garden hose to a drain in another room.