Search results

As I regularly use a grinder with a keif collecting screen at the bottom, I enjoy a nice Keif joint every now and again, as I sure most fellows growers must do... If you're stuck on a way to store it without losing out on keif being stuck to the storage container I've got a great solution. Use...

Next idea is to replace the shade with a single sheet of stucco aluminium 600x500mm that I will just gently curve over the entire width of the tent...

Most of the shape and bulk was produced in the propergator - I'm now just pruning fan leaves - looking from directly above and removing any leaves that are causing shadows. They will double in size during the stretch when I flip to 12/12 which is due tomorrow.

Yes - Im following the Canna Grow Guide completely...

Ended up with a very dense SCROG - as they came from a very old source mother, they were really bushy - got 92g from the last grow. Trying something a little more traditional this time to compare yields...

60/40 CocaClay Pebbles. Using full Canna Coca range, at strengths recommended by Canna Grow Guide for hard water/heavy feeding.

3 week old Critical Mass clones - growing in a 60x60cm tent under 400w MH. Due to flip tomorrow and move to Sodium bulb.

Been running a small grow in a 60x60cm tent with a "light tube" 400w lamp joined inline with the ducting... It was always resting out of square with the tent as in the small space the attached ducting was always pulling it... Bought some 1/2" aluminium angle and M3 nuts/bolts/washers on eBay...

Cat Attack - bloody Bridget...

Finished thing in place... Only needed 4 bolts to create a seal...

Final grow video...

Completely overhauled design - my measurements were off in the first design. Bought myself some cheap calipers and remade. This version is now held together with 8 M5 nuts and bolts. Enabled me to put a simple foam gasket in the joint. Printing cost in ABS, £13. Right hand piece fits over a...

Completely overhauled the design - clip block now snap fits over tent poles - now has 5 slots tilted from 0 degrees through to 45 degrees. The camera mount then goes in to these slots in the block at what ever angle I want. Cost about £10 to print in ABS...

Total yield = 93g of nice frosty heads... For my first grow I'm pretty happy - aim to double on next grow.

No where near the yield I was expecting :cry: Lots of fluffy buds and not much weight. Lots of causes - over watering - incorrect scrog (far too many stems - more sog) - didn't defoliate enough... Back to old school methods where I know what I'm doing.. Anyhow - what I did get is a blinding...

Sounds good to me... They've been in the dark since 9am - now 6pm - light due back on at 9pm, so I'll kill that and leave them. Harvest starting 1pm tomorrow...

Happy to do that - can I ask why though?

Final check of trichomes and this is being harvested tomorrow...

9 year old Critical Mass clone - no idea of genetics - cuttings came from a friend.