Search results

The pH is higher due to the highly aerated water; maybe someone will chime in with the technicals. Also doesn't peat moss have some sort of NPK value?

Using only organics and a soil/mix. Recently we setup a large reservoir of RO water to be aerated on a constant basis to be used for watering and flushing. Theres nothing in the water; five gallon buckets would be filled to mix feed. However the pH of the h2O alone is upwards of...

Both recommendations are the same. and I would not put something too runny in either of them.

Correct me if I am wrong but the average yield takes in to consideration two washes no? GW? If running full nugs and not breaking them down to re run them would lose a significant yield.

Buy a sutra vape or something similar. You drop a bb size dab in the chamber and puff away. Much easier than an OIL rig, you need to find glycerin tincture for those.

Your purge doesn't constitute your yield unless your selling tane soup (wink). Your yield is determined by the quality of the flowers then secondly by removing any lipids. (not considering skill) Typically on a good run of trim you can expect 10% yield waxed and less dewaxed. For nugs we see...

Let me be a positive word for the filter.... With a 1'' tube we would cut out only the center of a 12 cup filter and lay it over the lip using the dowel to push it to the bottom. The purpose is to prevent a direct back pressure spray of tane or leaf into your face so you don't need too much in...

That's interesting, I vote juice em next time!

Aww fawk I hit page 60 and not page 2... No wonder no one responded to him... :wall:

Mod needs to wash it's hand's. :bigjoint: When done correctly it should carry over much of the plants original smells. Freezing fresh material will increase this.. Also I am curious how did it turn black from a 15 second wash? Did you heat it?

Digital is best but you can monitor the temps with a meter too. I would use a sick pad in that case to make sure the heat is evenly distributed. (You can put parchment on top of it) I've heard about putting lids on to keep out moisture but I am weary of pressurizing butane. You could put a...

@R&R now that looks yummy. good job mate.

I'm curious to hear more about this?

Paper sucks, they are pulling it off the market. (can find it on amazon) Also you might be able to contact Herb N' Legends in Phoenix to ship you a MEGA version of the skilletool scraper.

I am at 1100ft and full vac for me is 28.9. Impossible to go to -30 in my location. http://www.anver.com/document/vacuum%20lifters/atmospheric%20pressure.htm

It sounds like the chamber is the same basic idea. My only concern is not being able to see the "muffin" and risking getting goo all over the pot. However 1'x'1 is pretty large for 3g runs. And for just a heat purge; for sure. Many makers low heat purge for 12-24 hours before vacuuming as...

I have no guidance on your chamber. .. but If your not going to vac you need more heat for longer. 100-120f for 24+ hr. Whipping makes it easier to evap but also degrades your product, It may smell wonderful but will not smell/taste like that for more than a few days. (Try moving it around...

Use the "basic up loader" on the bottom right when you click add image.

Most of the wax I have seen from a recycling machine are grey -black. Is there a trick to getting it yellow or white in a machine?

Or with a little prep work and some skill you can get a pristine 10% right out of the gate without having to remove a bunch of lipids at the end. (on trim) Fresh, frozen with controlled solvent use works well. Even if you did winterize you would see very little accumulation.