Search results

  1. M

    Best way to cut clones???

    Hey on some of these I took cuts from I went a bit above the node due to height restrictions. Being that Im planning on flowreing these should I cut them closer to the node?
  2. M

    Has anyone used uv and ir light?

  3. M

    Has anyone used uv and ir light?

    Im having trouble deciphering this. Does it list the uv nm? Today I ran 30 min in morning 30 min mid day and will do 30 at night. No problems so far. Maybe increase tmrw amd gradually throughout.
  4. M

    Best way to cut clones???

    Bd cake x fatso Bd cake × chem d Do si dos x grape pie Cannarado genetics
  5. M

    Best way to cut clones???

    Photos. Fem seeds.
  6. M

    Best way to cut clones???

    Time will tell. Ill letcha know.
  7. M

    Best way to cut clones???

    Sorry about my jumbled mess. Cut clones from these clones next. The best looking one out of the 3 strains. Putting the one I cut clones from into flower. So on and so forth. Clones of clones of clones of clones.
  8. M

    Best way to cut clones???

    I was planning on cutting clones from these 3 clones next. The best looking on from each strain. No "mother" plant. Was gonna stick the ones I cut colnes from in flower. Logical???
  9. M

    Will these clones survive in these tiny trays???

    There in rapid roo Rapid rooters. Cut at 45 above the third node down. Rooting gel. 5.5 ro water. Cut and misted.
  10. M

    Will these clones survive in these tiny trays???

    2nd time but its been yrs. Ill be happy if half make it. Thx for the advice.
  11. M

    Will these clones survive in these tiny trays???

    Ok thx man
  12. M

    Best way to cut clones???

    Cool thx again man.
  13. M

    Will these clones survive in these tiny trays???

    On most I just left the tops. On some I left one leaf below on. Only if the top was small tho.
  14. M

    Will these clones survive in these tiny trays???

    Cool. Thx man. There are 12 spots in each tray and I put 8 in there leaving the outside corners open. If the lid wasnt so shallow I wouldnt be as concerned.
  15. M

    Best way to cut clones???

    So I cut clones this morning and upon doing so noticed just how tiny my trays are. Will these clones make it???
  16. M

    Will these clones survive in these tiny trays???

    Bought some junk. Will my clones make it??? Thx guys.
  17. M

    Has anyone used uv and ir light?

    For reference
  18. M

    Has anyone used uv and ir light?

    Cool man. Thx. I will probably do something similar as my uv and ir run to the same control. I dont see me turning it on and off every 15 min tho. Do you have an amount of time you would reccomend at the end of each day???
  19. M

    Has anyone used uv and ir light?

    My ir and uv are connected. Uv and ir run down the middle of the light. Reccomendations???
  20. M

    Best way to cut clones???

    Thinking of skimming the second node down and cutting right above the third node down. This would give me one in the plug but not one out the bottom. Is this my best bet or would you go one more down?
Top