They will all do well on the same nutrients, they're all good heavy yielders and rather than pushing all to the max nutrient wise just give them all the least of them shows it likes. When any one starts to show any tiny indication of leaf tips burned it's too much, back down. None will starve or burn in any decent range, they'll all be fine.
Pick whichever 5 you want. If you have a few $$, set up a vertical cooltube in the center of the tent even if you have to DIY the cooltube out of several candle chimneys, then heat won't be an issue and you could run 1800w. You'll have a hell of a setup, nothing better.
Search on here for candle chimney cooltube, or just buy a couple if you can afford it.
I am familiar with all those strains except master kush, but they'll all grow ok in any decent nutrient range and if you are going to train them into a vertical cylinder scrog varying heights won't be an issue, you just train them all however you like to make them all as consistantly tall as possible. It's good you have a range of strains it will give you selection to see what works and yields best and what you like the taste strength and high of the best.
What type of oxygenation will you be using? DD used large air pumps, and high volume water pumps and that's important if you want those results even on a small scale do not skimp there, and that will for sure require a chiller so you'll be good to go. If you can't afford big air and water pumps there are ways to oxygenate well with only a good water pump. bio balls and waterfalls, it's called a degassing column. We have rarely seen them used but many of us have talked about how it would be ideal. Don't leave out dd's waterfalls even if using a big air pump, at least duplicate one big one, degassing is important. His degassing and oxygenation was all his water pumps and small waterfalls and all his long BIG pvc drain tubing with water surface area exposed to air, and the big waterfall going through the screen, but that could be all reduced with one degassing column with bio balls and no air pump as long as you had enough water flow. But having multiple sources of air and degassing and waterfals and pumping and stirring etc gives lots of redundancy and might be preferrabe that way... No comparisons have been done that I'm aware of as far as cutting out wasted overhead in his system if there is any.