3 weeks into veg, what u think guys

*BUDS

*BUDS

Well-Known Member
Sounds good. For the last week of veg can you raise the smaller ones (on pots or bucket etc) an inch or so above the bigger ones for faster growth before flowering.
 
209whitebread

209whitebread

Active Member
I was thinking the same thing, these damn hs are taking offf on the others....i think i should raise the lights up some more and put buckets under the shorter ones to help like u said, i just dont want to burn them there last week right now there about 1-1 1/2 ft away from the light now i had them closer but some started to burn a lil or the leaves would sorta taco up
 
lrg

lrg

Active Member
Hey whitebread,
I just took a look at your grow.

These are two things I would

1. Veg for another month or two

2. and this why, you could lst, top, fim etc.
you have very healthy plants but only one cola

https://www.rollitup.org/advanced-marijuana-cultivation/151706-uncle-bens-topping-technique-get.html

https://www.rollitup.org/advanced-marijuana-cultivation/200413-fimming-my-blaze-complete-how.html

these techniques with a little extra time will increase your yield by a very large margin

Start tying branches off or pinching and bending over.

All these techniques make it stronger while allowing light to reach the areas once covered by foliage
 
MC Bud

MC Bud

Member
They look good. Irg has a good point too. Lst and topping can definitely help increase yield when done properly. good luck.
 
209whitebread

209whitebread

Active Member
thanks for the advice, i topped or fimmed the 4 biggest ones because of there size and i only have so much room left before everything is bunched up which i dont want worried about mildew problems, my big question would be if i wer to hold off another 3-4 weeks how much of a diifference in yield and or potency should it make, in your opinion
 
209whitebread

209whitebread

Active Member
i did look at the uncle bens topping technique on colas im just a F.N.G so i dont knw wer to make those percise lil cuts so what ive been doing is bending branches down to spread them out better to get more light and breathe, i only have 2 600's and im thinking the longer i wait the less light and yield im going to get, im open to any ides on this..
 
lrg

lrg

Active Member
Hey I know I sent a P.M

BUT!

I just wanted to let you know you made a great choice
even just bending will help level your foilage creating an even surface to better let light through.

Hoping for updates!!

FYI!

If you put your grow link as your signature it'll provide more hits on your grow/thread
 
L

lostNug

Well-Known Member
U don't need to worry boutt makiin a precise cut at all. Just cut a couple tops off (few inches atleast if u wanna make clones) or just pinch off 3/4 of a new growth. No need to precise at all. I've accidently topped couple plants when I supercroppingg and they grew just as fine as ones I took my time topping.
 
wheezer

wheezer

Well-Known Member
lostNug said:
U don't need to worry boutt makiin a precise cut at all. Just cut a couple tops off (few inches atleast if u wanna make clones) or just pinch off 3/4 of a new growth. No need to precise at all. I've accidently topped couple plants when I supercroppingg and they grew just as fine as ones I took my time topping.
Click to expand...
Do you know what "FIM" is? it means "fuck I missed" method of topping. perfection is not needed.
 
You must log in or register to reply here.
Top